Question about Chevrolet Blazer

1 Answer

1995 blazer s-10 4l60 e drive down block shifts get bad wont pull so i parked went to check for reverse and drive no reverse no drive nothing shut off start right back up and have both again ??

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 321 Answers

Presuming the fluid level is full,it is quite common for a broken reverse sun shell to give the symptoms you are experiencing,as well as some other areas that could also give similar symptoms such as burnt clutch packs,or the torque convertor going bad,and eventually the vehicle will stop pulling altogether.If the fluid is full,the problem is pretty much going to require trans removal and repair.Further diagnostic would include installing a mechanical oil pressure gauge onto the transmission to monitor main line pressure and see what it's doing while the trans is acting up and not pulling,and this does require a gauge capable of handling 300 psi.Also pull diagnostic trouble codes from the vehicle computer (PCM).Good luck.

Posted on Aug 30, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My transmission in my 97 ford f150 wont move unless i put it in 4 low and now wont switch out of 4 low


Its Possible the chain in transfer case is stretched I had the same problem a used case was 250 at my local salvage yard

Nov 23, 2012 | Cars & Trucks

2 Answers

Cannot shift from drive to park but can shift using shift lock release


check your brake light switch for proper adjustment as wel as the electrical connection at the switch also check your fuses and make sure your brake lights are working

Aug 29, 2012 | 2006 Hyundai Sonata

2 Answers

How do you adjust the shift cable on a 1995 gmc jimmy, wont go into reverse or park.


On the 1995 Jimmy, the shift cable can come loose on the mount on the side of the transmission where the cable meets the trans. When it slips, the alignment goes off and causes the driver to not be able to put the trans into park. If you take a long stick you can push the shift arm on the trans to the park position and your trans will go into park.....what you (and I) really need to know is how to take the shift cable mount apart and reset it.

Aug 05, 2012 | GMC Jimmy Cars & Trucks

1 Answer

1997 chevy blazer 4*4 will not go into reverse , drives and shifts sluggish in forward gears . parked overnight went to back up the next morning and vehicle was like neutral in reverse. fluid level is ok .


You may have a bad revers solenoid. Check the fuse and look for any of the fuse to be bad like the transmission fuse. Best thing to do is get the blazer scanned at Auto Zone free of charge for any DTC codes that may be affecting your transmission's performance. Try this, place the ignition to the run position and pull the ECM(BATT) fuse out for 30 seconds and then place it back in. Start the Blazer, it may stall but let it. Just start it again the ECM is just relearning the engine and transmission, let it idle for 1 min and then go for a test drive. This should reset everything in the truck's ECM like the day it was first started and any DTC code will be new and active. Do not add any additives like lucas transmission fluid repair, that will just make it worst. Any additive that may the transmission thicker will make the fluid retention more making the shift solenoid stick causing shift conflicts. Good luck and keep me posted. No revers is ether a bad solenoid, bad PCM signal, or broken sun gear. 

Jun 12, 2009 | 1994 Chevrolet C1500

1 Answer

1995 crown vic gear problems/gear shift wont lock


most likely the shift tube bushings are bad- you may have also lost a few screws in the shift tube or they could just be loose. you have to pull the steernig column down to inspect/repair it.

May 30, 2009 | 1995 Ford Crown Victoria

1 Answer

1995 Chevy S10 Blazer will not go into park.


theres a shift cable if its floor model,linkage for column model.

Apr 25, 2009 | 1995 Chevrolet Blazer

1 Answer

1995 chevy s-10 blazer does not shift gears


Tell me something. Does it seem like the truck is in 3rd gear when you shift in D.If is it I know what it is.

Jan 22, 2009 | 1995 Chevrolet S-10 CA Edition

1 Answer

4 wheel drive not working


Vacume lines or vacume switch on transfer case,or vacume pod to front axle.

Jan 05, 2009 | 1993 Chevrolet S-10 Blazer

1 Answer

Wont shift out of reverse,but the shifter moves up and down freel


your linkage on the transmission must be off. try having someone move the shifter while you watch the linkage arms under the car on the trans to make sure its all intact. it could be a loose or broken bolt on the trans causing it to not disengage from reverse this will cause it to not start.

Nov 30, 2008 | 1996 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

199 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...