Question about 2001 Ford Escort ZX2

4 Answers

Location of 2001 ford zx2 speedometer sensor

Where is this part located, do i access from the top or underneath, thanks

Posted by on

  • palmerdt Aug 29, 2008

    where underneath, front, right/left side, back

×

4 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 726 Answers

Herman u just copies ekse is soulotion and dont ask them to rate u so rude

Posted on Aug 30, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 13,433 Answers

Hey,

The Vehicle Speed Sensor is located on the lower rear of transaxle. Raise and support vehicle.

Thanks,
Ekse

Posted on Aug 29, 2008

  • Ekse Aug 29, 2008

    Hemantraj your incompetence is getting on my nerves.

×

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,071 Answers

The speedometer sensor located at the transmission ,

Hope this may help

Regards,
Votit

Posted on Aug 29, 2008

  • LORETO LACARON
    LORETO LACARON Aug 29, 2008

    I know on the older models that the cable went right in to the top of the tranny and the gear was plastic and would wear down and not work or the cable would get pinched

  • LORETO LACARON
    LORETO LACARON Aug 30, 2008

    The speedometer cable needs to be lubricated or replaced. Too much friction on the internal drive wire causes it to hang up and release causing the jumping and noise. If you don't fix, it will get worse and then break.The separable connection between the cable that connects to the vehicle speed sensor on the trans and the cable that attaches to the speedometer. The Contour uses a plastic connection where you squeeze the colar and disconnect the cables. Then lubricate both cables by running some oil down them, and re-connecting.



    Hope this may help;



    Regards,

    VOTIT

×

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 638 Answers

Its underneath.sir.

Posted on Aug 29, 2008

  • 4 more comments 
  • hemant somaiya
    hemant somaiya Aug 29, 2008

    please do rate the solution .sir.thanks.

  • hemant somaiya
    hemant somaiya Aug 29, 2008

    its located on the lower area.sir.

  • hemant somaiya
    hemant somaiya Aug 29, 2008

    in the inner side of support vehicle

  • hemant somaiya
    hemant somaiya Aug 29, 2008

    The old trans had the speed connector on the right side of the trans. Like the old cars with the gears. The new one does not have that same connector. I cut the connector to make it work.. But when I did that it made the speedometer run fast.

  • hemant somaiya
    hemant somaiya Aug 29, 2008

    The wire that I cut is on the speedometer side. The other senor is OK. It has 2 wires running to it red and the other one is green. On the 97 the speedometer is on the passenger side on the 2001 it is on the passenger side, but run a long cable that run back to the driver side. also the 2001 censor is on the top and the 97 goes in where the old cable hookup

  • hemant somaiya
    hemant somaiya Aug 29, 2008

    I'm thinking you may have hooked up your speedometer to the sensor for the turbine shaft, and not the transmission output shaft. The transmission turbine speed is monitored by a Turbine Shaft Speed Sensor (TSS). The turbine shaft spins anytime the engine is running. The transmission output shaft does not turn unless the car is moving. The Vehicle Speed Sensor (VSS) monitors the output shaft and it's signal is used for the speedometer

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is is sensor switch located on 2001 ford escort zx2


It 's not the sensor. When they fail the PCM goes to default mode and turns the fan on with the engine on. Your problem is a fuse/s, wiring, relay, resistor, or the fan is dead.

Jun 09, 2015 | 2001 Ford Escort ZX2

1 Answer

Where is the MAP sensor located on a 2001 Ford Escort ZX2?


i think its on the fire wall with a vacuum line going to the intake look at the vacuum line for splits the line fails more than the sensor

Jun 24, 2012 | 2001 Ford Escort ZX2

1 Answer

Where is the crank sensor located on a 2001 ford escort zx2 model?


The Crank Sensor is on the block, below the Exhaust manifold. You will need a T-20 Torx bit to take loose the bolt that holds it in. The wiring for it goes down the block on the front side and is off the same harness that the coolant sensors are on.

May 26, 2011 | 2001 Ford Escort ZX2

1 Answer

Where is the knock sensor located on a 2001 ford escort zx2


On the back of the engine, under the intake manifold. It has two wires going to it. There is also an oil pressure switch near it but it only has one wire going to it, that is how you tell the difference. The connector on the knock sensor is a light green color.

Feb 27, 2011 | 2001 Ford Escort ZX2

2 Answers

Location of cam and crank position sensors


The cam sensor is located at the front right front side of the cylinter head, while you are facing the engine.---------- The crank position sensor located below the pcv valve that is located on block not the valve cover, its below the exhaust manifold. You will have to remove the catalytic converter to see the exact view of both the sensors. The camshaft sensor is on the head. The crankshaft sensor is in the block, just below the exhaust manifold. ------------ Thanks.Helpmech.

Nov 12, 2010 | 2001 Ford Escort ZX2

1 Answer

2002 Ford Escort ZX2 where is the map sensor located


the map sensor is located on the intake manifold usually on the back of it to the right

Nov 20, 2009 | 2001 Ford Escort ZX2

2 Answers

Where is the mass air flow sensor located on a 2001 ford escort - not the zx2 coupe


not sure but you can go to autozone.com and sign up then put make,model and year of your car and it will show you a diagram..just look for diagram of your car motor..

Aug 11, 2009 | 2001 Ford Escort ZX2

Not finding what you are looking for?
2001 Ford Escort ZX2 Logo

634 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Ron Lankford

Level 3 Expert

5386 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...