Question about 2000 Honda Accord

1 Answer

2000 Accord turn signal problem

2000 Accord EX--have a problem with my turn signal flasher--when I signal for a left turn the frequency of the flash is normal but when signalling a right turn the flash is much higher frequency. Looking at the front signal lights-- those on the right only show at a lower brightness- the 2 bulbs cannot be seen in daylight conditions as only one filament lights up ) -- the left is normal brightness. The emergency flasher flashes at a normal rate. Is the problem with the flasher/relay or the light bulbs--how could I tell---thanks

Posted by on

  • Anonymous Mar 28, 2014

    I have a 2006 Accord EX 4 cyl with 106,000 miles. It's never been in an accident. Just noticed today that the left turn signal does not come on at all in front or back - no arrow, no light, no flash. Also, when I checked the emergency flasher, it does not come on on the left side. What am I up against?

  • Anonymous Mar 30, 2014

    hazards work and left turn works all bulbs are good and replaced relay for turns

×

1 Answer

Either the front or the rear turn signal bulb is blown, that is why the flash frequency is high. replace the bulb and the problem will be solved. best to replace both the front and rear turn signal bulbs. good luck.

Posted on Sep 01, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i change a turn signal relay on a 2000 Chrysler Concorde


The Combination Flasher, also referred to as the combo-flasher, is mounted to the in-line bracket which is located to the right of the Junction Block. The flasher can be removed by pulling in a rearward direction. The left under panel silencer duct must be removed to access the flasher. The combo-flasher is black in color for ease of identification.
The Turn Signal and Hazard Warning Flasher is combined into one unit called a Combination Flasher (Combo-Flasher). The combo-flasher controls the flashing of the hazard warning system and the turn signal system. An inoperative bulb or incomplete turn signal circuit will result in an increase in flasher speed.

Ref: http://www.10w40.com/questions/auto-repair-questions/where-is-the-flasher-relay-on-a-2000-chrysler-concorde
Good Luck

Mar 03, 2015 | 2000 Chrysler Concorde

1 Answer

When i turn the signal lights for left or right turn the emergency flasher start flashing all four turn signal lights. the emergency flashers work ok


ck your turn signal switch wiring connector because it is more than likely has been hot and melted some connections.

Oct 18, 2014 | 2000 Kia Sportage

1 Answer

I have no signal lights, left or right, on my 2000 Oldsmobile Intrigue. I was having a problem with a front bulb not contacting properly making the right signal flash rapidly. I left it flashing while


Check if your emergency flashers still work. You possibly need a new flasher. Some cars have separate flashers for turn signals and emergency flashers, but some they are both together. If your emergency flashers still operate leave them on and find the flasher (follow the clicking noise the flasher makes) and see if there is another flasher right next to it. swap with the emergency flasher and see if your turn signals work again. If so, replace the faulty flasher.

Jul 26, 2014 | 2000 Oldsmobile Intrigue

1 Answer

Turn signals and hazard flasher stopped working in my 2000 Toyota Sienna. Checked fuses and both are good. Is the relay the only other likely problem? Thanks!


Yes, you are on the right track. More than likely it is a defective flasher relay as one relay controls turn signal and hazard flash. The flasher relay is located behind the left side of the instrument panel.

May 01, 2010 | 2000 Toyota Sienna

1 Answer

I need to know where a flasher is located on a Honda Accord Ex?


its in the underdash fuse/relay box , left kickpanel , since you have the new part it should be easy to identify now .

J5

Jan 18, 2009 | 1997 Honda Accord

1 Answer

1988 acccord turn signal acts like light is blown


Check the earth to the offending light unit. Clean all the relevant connections. You could also try fitting a temporary earth cable and watch for any improvement. If you find that there is improvement in the operation of the indicator/flasher make the temporary earth cable permanent.

Nov 26, 2008 | 1988 Honda Accord 4 Door

1 Answer

Passat 2000 turn signal problem


sound like you have a poor earth on the rear lights or indicator circuit

Oct 22, 2008 | 2002 Volkswagen Passat

Not finding what you are looking for?
2000 Honda Accord Logo

Related Topics:

1,007 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...