Question about 1995 GMC Suburban

3 Answers

1995 GMC Pickup Won't Start After Sitting Over Night

I just replaced a shorted ignition coil and dirty fuel filter. After several cranks the engine finally started and seemed to run OK. However, after sitting over night the engine won't start again.

The fuel pump relay is OK and the voltage at the relay terminals seems OK too. Any help will be appreciated.

Posted by on

Ad

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

93 GMC PICKUP WONT START REPLACE RELAY SWITCH'FUEL PUMP' MODULE CONTROL BOX' POUR GAS IN TROTTLE BODY TRY TO RUN

Posted on Jan 17, 2009

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • GMC Expert
  • 291 Answers

Ronald Mueller probably has the answer. The logic behind his reasoning is that if you had fuel line problems to start off with, or suspected fuel line problems which caused you to change the fuel filter, the next bet is the fuel pump. There are two valves in the pump body which, on older cars (pre 1970 or so) were replaceable, but on later vehicles, when they go they go and you have to get a new pump.
you can spend money and have the pump pressure checked by a service expert if you have doubts, or just get a new fuel pump.

Posted on Dec 21, 2014

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,263 Answers

You have a weak fuel pump and it should be replaced. according to your observation the engine finally started but it was after alot of cranking. this indicates that the pump is not working like it should and can't keep the system primed.

Posted on Aug 29, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

97 gmc 1500 350 5.7 new fuel pump and filter it cranks over but wont start


Kelly, could be a few issues, security lock out, crank sensor, fuel pump fuse/relay, faulty new pump,faulty ignition switch, etc. Attached links may help you diagnose the crank no start issue you are having.
Check the attached links,video,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
96 98 Chevy pickup cranks but won start first steps
GM no start no fuel troubleshooting
No Start No Spark Cranks OK GMC Jimmy S10 Blazer


Apr 24, 2016 | GMC Cars & Trucks

1 Answer

Truck won't start


Sounds like you have several problems.
If the engine will not crank, do you have power on the purple wire on the small starter terminal when the key switch is in the start position ?

Apr 14, 2013 | 1995 GMC Sonoma

1 Answer

1995 ford contour cranks but won't start, change fuel filter, fuel pump, and spark plugs. Not getting any spark.


Have you ever heard of testing before replacing parts ? Fuel pressure an flow tesing , testing the electrical circuit for the fuel pump , amp draw testing , voltage drop testing etc... Thier are no magical fixes in auto repair . No spark ! check B+ voltage an ground circuits for the ignition system , Ignition System Designs Operation and Testing an SD Premium video

Jun 18, 2017 | 1995 Ford Contour

1 Answer

Crank but won't start


You'll have to figure out if it is a fuel or ignition problem.
Is the check engine light on ? Have you checked for trouble codes ?
It could be a relay, the ignition module, coil, fuel pump, or a list of other things.

Jul 09, 2012 | 1995 Ford Mustang GT

1 Answer

Cranks fine engine runs fine but you turn off. it is hard to crank keeps turning over finally cranks


CLEAN FUEL INJECTORS.THEY ARE FLOODING THE ENGINE.WHEN YOU TURN OFF ENGINE DIRTY CLOGGED FUEL INJECTORS WILL KEEP LEAKING FUEL FLOODING ENGINE.ALSO REPLACE AIR FILTER.

Oct 25, 2010 | 1995 GMC Yukon

1 Answer

1997jimmy cuts off and starts back up when its been sitting for a while. replace iginition modulator, fuel filter, and fuel pump don't know what it is


Here's one thing you can do, carry little gas with you and when it cuts off, pour some gas down the intake manifold or throttle body. If it starts you probably have a fuel problem. If it doesn't start you most likely have a ignition problem. Using a test light check for Power going to your coil or coils. To rule out the ignition switch. But if I were to take a guess, ignition coil or coil wire, and if it has a distributor, ignition module pickup and rotor. Good luck.

Jun 19, 2010 | 1997 GMC Jimmy

1 Answer

1995 olds 88 3.8 L. Sometimes won,t start.Cranks and immediatly dies on 1 to 10 attempts.Once starts ,runs fine. already replaced crank pos. sensor. Can hear fuel pump prime up when key is on. No check...


check the ignition control module wires are shorting out? Try the wiggle test next time no start. wiggle the wires and see if it starts.This is a factory mechanic approved test procedure.

Aug 07, 2017 | Oldsmobile Delta 88 Cars & Trucks

1 Answer

1995 buick lesabre limited, cranks but wont start...what should i do?


May be fuel related or ignition related:

Fuel: Obtain a can of "starting fluid" from an auto supply store. Spray directly into air intake for two seconds. If car "kicks" and trieds to start, then the problem is fuel-related. If you spray more, then it may start.
Could be: Fuel filter or fuel pump.

Ignition: Remove a sparkplug cable and lay it down on a metal part of the engine. Have someone crank the starter while you look for a spark from the cable end to the engine. If no spark, it could be several things:
distributor rotor, distributor cracked and/or wet on the inside, ignition coil.

Oct 06, 2009 | 1995 Buick LeSabre

2 Answers

1993 GMC 1500 Engine dies while driving


When you say "cranked but would not turn over" I assume you mean it turned over but would not crank. Otherwise, it does not make sense.

Assuming that, I would replace the fuel filter. It is a cheap part and easy to install. What happens is dirt gets in the filter and stops the car because it is not getting fuel. After sitting a while,the fuel dains out of the filter along with the debris and it works well until it happens again (usually when you are low on fuel). It is a cheap fix and probably will solve your problem.

Mar 19, 2009 | 1993 GMC Sierra

2 Answers

94 Aerostar won't start. No fire


1 Inspect Battery Damaged or faulty battery and/or connections. here is a list of things u can check hope this helps Shaun 2 Inspect Coil - Ignition Damaged or faulty ignition coil or ignition coil circuit. grey_line.gif 3 Inspect Fuel Filter Clogged or dirty fuel filter grey_line.gif 4 Inspect Fuel Injector Pressure Regulator Faulty fuel injector pressure regulator or circuit. grey_line.gif 5 Inspect Fuel Pump Improperly functioning fuel pump or circuits. grey_line.gif 6 Inspect Wireset Damaged, worn, or deteriorating spark plug or coil wire(s). grey_line.gif 7 Inspect Control Module-Ignition Faulty ignition control module or circuit. grey_line.gif 8 Inspect Solenoid Switch Damaged or faulty solenoid switch or solenoid switch circuit. grey_line.gif 9 Inspect Starter Damaged, worn, defective, or faulty starter or starter related circuit. grey_line.gif 10 Inspect Neutral Safety Switch Damaged or faulty neutral safety swittch or circuit. grey_line.gif 11 Inspect Fuse Corroded, burned, or shorted fuse may be interupting power source. grey_line.gif 12 Inspect Fusible Link Corroded, burned, or shorted fusible link may be interupting power source. grey_line.gif 13 Inspect Battery Cable Corroded, broken or poorly connected battery cable. grey_line.gif 14 Inspect Spark Plug Wire Loom - Performance Improperly adjusted or worn/malfunctioning carburetor. grey_line.gif 15 Inspect Distributor Cap Loose or cracked distributor cap grey_line.gif 16 Inspect Distributor Cap And Rotor Kit Loose, cracked, or worn distributor cap and ignition rotor. grey_line.gif 17 Inspect Fuel System Pressure Incorrect fuel pressure being delivered to carburetor or fuel injection system. grey_line.gif 18 Inspect Fuel Injector Plugged, dirty or poorly connected fuel injector. grey_line.gif 19 Inspect Ignition Switch Worn, damaged or faulty ignition switch or circuit. grey_line.gif 20 Inspect Spark Plug Fouled, damaged or broken spark plug(s). grey_line.gif 21 Inspect Belt Incorrectly routed, adjusted(tensioned), missing or worn drive belt(s). grey_line.gif 22 Inspect Timing Belt Slipped or broken timing belt. grey_line.gif 23 Inspect Timing Set Slipped timing chain or worn timing gear(s). grey_line.gif 24 Inspect Fuel Tank Contaminated fuel from rusted or deteriorated fuel tank. grey_line.gif 25 Inspect Ignition Timing Incorrectly adjusted engine timing. grey_line.gif

Nov 23, 2008 | 1994 Ford Aerostar Extended

Not finding what you are looking for?
1995 GMC Suburban Logo

373 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...