Question about 1986 Ford LTD

1 Answer

1986 ford ltd

Car wont idle you have to pump the gas to keep it running changed the gas filter and plugs

Posted by on

  • 1 more comment 
  • Coss May 11, 2010

    Injected? Or carb?

    How many miles on the car?

    Has any major work been done to it?

    This is a 22 (almost 23) yr old car.

    Depending on what has been done (or more importantly, what hasn't been done) will have differernt answers.

  • Anonymous Mar 15, 2014

    how many fuel pumps does a 1986 ford ltd have

  • Anonymous Mar 24, 2014

    Put new battery, air fikter and brather filter, will crankover but will only run 3 to 5 seconds


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,263 Answers

Tps sensor is bad(throttle position sensor)

Posted on Aug 29, 2008

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Gas release in ford tempo 1986

There isn't one. You have to pull the fuel pump fuse or relay. Start the car and let it run out of gas to relieve the pressure. All I do is loosen the nut at the fuel rail or fuel filter with a cloth/rag around it to keep it from spraying on me.

Dec 20, 2014 | 1986 Ford Tempo

1 Answer

Sputters at full throttle and wont idle

Run pressure test on your fuel injectors. Fuel pump might not be suppling enough fuel line pressure.

Apr 13, 2014 | 1986 Chevrolet S-10 Blazer

1 Answer

86 f250 runs fine for a while then starves for gas

Starves for gas??? Starts to stall? Sputters idles funny?? Gas and O2 issues ackd alike. Gas starvation is usually a filter problem or god fobid the Fuel pump. Do you smell gas? See a leak??? Need more info here

May 19, 2012 | 1986 Ford F 250

2 Answers

1986 nissan truck starts fine runs a min. then stops.Driving it you have to keep pumping gas for it to keep running

Hook up a fuel pressure tester start and let run until dies and check pressure if plenty of pre.ssure If this is a carberated engine tune your air and fuel mixture jets located in front bottom of the carb.., hook up vacuum and set to your hightest reading and then set your idle screw to prefered idle which is around 8 RPM If this is a injected system hook up a fuel pressure guage and start engine and let it run until it stops keep an eye on pressure to see if the pressure drops or stops if so replace fuel ****

Mar 05, 2011 | 1986 Nissan Pickup 4WD 1986

2 Answers

I have a 1986 Ford LTD Crown Victoria Station Wagon. 302 Fuel Injection. When I turn the key on I use to here a the Fuel Pump come on and then a few seconds later after the pressure buildups up it stops....

sound like your fuel pump is failing
check the fuel pressure at the fuel rail
should be 35-45psi and you should get about a liter of fuel in less than one minute

Apr 04, 2010 | 1986 Ford LTD

1 Answer

1986 Ford Ranger -- 2.9L V6

Could be a bad Throttle position sensor, and starter solenoid.

Aug 13, 2009 | 1986 Ford Ranger 2WD

1 Answer

1986 Ford LTD 5.0 engine; Failed HC emissions. Did tune up, new air filter,oil change. 2 bottles of HEAT and 1 bottle of Guarantee to pass. HC came back 2.90 passing is 2.50. What could it be.

Heat is pretty much will counteract the effects of the other additive you used. Run that stuff out of there and try using 3oz of acetone per 10 gals of fuel and possibly adding a couple of degrees more advance to the timing. If you know anyone with a gas analyzer, perhaps they can help you get it set up.

Jul 09, 2009 | 1986 Ford LTD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

159 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

68970 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22026 Answers

Ron Lankford

Level 3 Expert

5383 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides