Question about Mercury Grand Marquis
The condenssor is mounted to the front of the radiator. you have to have special tools to remove this also you have to make sure the pressure is out of the system if not this could pose a real injury hazard.. remember that just cuz it leaks doesn't mean that there is no pressure. also you need to replace the dryer and all O-rings prior to recharging
Posted on Aug 28, 2008
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: mercury grand marquis
it is on the fender near the battery and is also referred to as the starter solenoid (if you follow the large wire from the positive terminal of the battery at the other end will be your relay/solenoid)
hope this helps!
Posted on Feb 28, 2009
Raise car under frame then put jack under axle before removing the shock.
Can use locking pliers to hold the shaft from turning (may have to cut away dust boots). Top nuts are accessed and can be seen from the wheel wells or from the gap between the trunk and mount frame (can't see nut from this angle). Take care with fuel lines near the driver side nut.
Preventing shafts from turning on new shocks will be tough. Make sure you have a proper tool to fit top of shaft with enough room between top of shaft and trunk (gap decreases as the nut is tightened) so the tool can be removed.
Posted on Mar 30, 2009
you will need the proper Quick Disconnect tool, Look on the Frame rail for the filter, remove filter from the spring type retainer, remove the safety clips on the lines but not remove them completely, insert the disconnect tool & push into the fitting of the fuel line, push line & tool into eachother then pull filter away from line, if not done properly you will have a big problem putting the line back on
Posted on Oct 28, 2009
Check your fuses first, If not the fuse most likley it is your wiper motor. Try to turn on the motor and wiggle the wiper arm back and forth not to hard but enough to put pressureon the motor, This will assest the motor in to oppration if it starts and stops or starts and does not stop untial you turne it off its a week motor....If it still doesent work most likely it is the wiper motor anyway.....Best of luck any futher questions fell free to ask and good luck on the project I belive the motor is somewhere around 50.00
Posted on Dec 04, 2010
Tips for a great answer:
Oct 10, 2017 | 1996 Mercury Grand Marquis
Apr 12, 2013 | 1996 Mercury Grand Marquis
Mar 08, 2012 | 1996 Mercury Grand Marquis
Mar 19, 2011 | 1996 Mercury Grand Marquis
Feb 06, 2011 | 1996 Mercury Grand Marquis
Mar 28, 2010 | 1996 Mercury Grand Marquis
Jun 23, 2009 | 1996 Mercury Grand Marquis
Mar 30, 2009 | 1996 Mercury Grand Marquis
40 people viewed this question
Usually answered in minutes!