Rear turn signal flashes rapidly but front does not flash at all .but all lights work, all on right side

Get the left signal to flash fast then walk around the car to see which light isn't flashing then change the bulb or socket if they all appear to be flashing (front and rear) turn on the right turn signal then look into the front and rear lens and count the number of bulbs flashing, now do the same thing on the left. Many times there's more than 1 bulb in each lamp. I hope this helps. Take care.

replace the right rear bulb. the quick flashing indicates a bad bulb. it could be a wiring problem to the rear for the signal light that you will have to check out starting at the socket and working forward.

I would change out the turn signal bulb on the right front. A blown bulb can cause the fast flash issue. The signals staying on is not related to the bulb being blown. That is most likely a problem with the multifunction switch, the knob you use to signal.

why skip RR lamp? what does IT DO? be like 1st 1st look.
dim, out, fast?

the rapid is talking to you
it means current is wrong,
shorted, or open lines. to the right.
its the wiring
if the bulbs are like 1157 brass base bulbs
why not replace them first , they can short inside,
asking online for guessing is silly, why listen to 10 examples for this.
but is cut wires.
shorted wires.
keep i mind the blinker asks funny for both opens and shorts
its a feature, that.
low current or too much.

the acid test is connect 2 TEST bulbs in parallel to the multi-function switch output right side,
blinks ok now, bingo bad lamps or bad wiring, from there to the right side.

if the hazard fails you never said????
if rigth front is dim or dead the bulb is blown or shorted
if new bulb there , then the wires are shorted.
to it.
the only help on line worth squat is how to test and use your meter.
you can, check for voltage
you can check continuity on that line (its just 1 wire)
and check for shorts on that wire to ground (lamps pulled right side to do that, lamps read 0 ohms cold)
look for collision damage RF? behind lamp sockets?
be first.
in my book.
looking is always first. sure.


I have your SM book open now, chapter 8w-50
the haz/blink module has just 2 pins, left and right out.
pin 3 on the module runs front and rear blinks, (a fact to know)
RF is BR/RD, brown -red stripe?
all comments USA on USA forum. USA car.
ok?

the right side lamp (sidemaker) only blinks turns if parks ARE oFF

Id try 2 new blinker lamps front and 1 rear.
that be first. or test the lamp on a battery , and no not get burned fingers hot wring a shorted lamp.

wish i knew
what rear did
and what both did on HAZ
out, dim or to fast.

Check the front lights. Usually if i flashes fast it indicate a bulb is out on that side.

Your front turn signal socket is shot. Buy a new one at the dealer for about 30.00. It will fix it. You may be able to clean it and wiggle it to get it to work. But it wont last very long. I had the same problem. Replaced the socket and it is fine. Note: If one side is bad the other side it not far behind. Probably 2 or 3 months it will go also. Good Luck.
Bill

if you're getting a more rapid flash in the front you have a possible blown relay to the back. Check fuses first and see if those are out.

This fast flash is caused by a burnt out bulb in the front or rear.