Question about 1998 Chevrolet K1500

1 Answer

Rpm gage is not working properly when you acceleration is goes up to 2 then gets stuck it does that sometimes and sometimes does nothing.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 21 Answers

You most likley have a loose wire somewere chech the conecttions to the back of your tach and your coil

Posted on Aug 28, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2000 Chevy s15 Rpm and Gas Gauge is not working


I didn't see an s15 in that model year, in my database?
If the speedometer works but the tach doesn't, I think something is wrong with instrument cluster?
GM has had a problem with fuel gage sending units. The sending units are not hard wired to instrument cluster, they send signal to pcm, the pcm sends serial data to instrument cluster, telling the cluster the gage settings.
It may be possible to use different size resistors in place of the fuel level sending unit, to see if fuel gage reacts properly to different resistors, if the gage reacts properly, then I think the problem is the fuel gage sending unit.

Nov 02, 2016 | Chevrolet Cars & Trucks

1 Answer

I have audi A6 2.4 model 2006. When I start the car in morning, the battery sign appears after a couple of seconds. But when I accelerate a bit it goes away. The normal position of the rpm should be about...


Afraid not. Although the light goes out it still may not be charging very little charge will put the light out. the other reason I feel it's the alternator is instead of rpm increasing it should decrease as a properly charging alternator should pull the engine which should decrease the rpm

Aug 10, 2014 | Cars & Trucks

1 Answer

When accelorating rpms and engine get stuck


Put a vacuum gage at e port on intake,low vacuum while accelerating could indicate a block catalitic converter or remove o2 sensor at manifold to remove restrition ifroad test ok change cataltic conv. sometime you could exhaust pipe very blue ish

Apr 22, 2014 | Chevrolet TrailBlazer Cars & Trucks

1 Answer

My gas needle on my 2004 buick lesabre is not working also the rpm needle does not work how can i fix?


Sounds like you may have a problem with the circuit board on the backside of the instrument cluster.

Sep 23, 2012 | 2004 Buick LeSabre

1 Answer

I have blazer 2006. the RPM gage is below 0.5 that makes the head lights weak and cooling goes hot(i dont mean heating ) when i stop while the engine is running but whenever i accelerate the cooling become...


{: ) It's possible that you need to clean your throttle body for carbon build-up. Also check your air filter and spark plugs as well. Also have your engine cooling fan checked by mechanic for proper slack.

May 10, 2011 | 2006 Chevrolet Trailblazer

1 Answer

1995 t-bird 4.6 V8 190,000 miles car will stumble and sometimes stall in weather below 50 degrees or so. seems to do this when going from idle till you get over 1000 rpm but will run fine when idle until...


DOES YOUR CAR STALL OR DIE AT A COMPLETE STOP? SPUTTER FOR A SECOND OR TWO WHILE DRIVING, RPM GAGE PEG OUT THEN ENGINE SHUTS DOWN? YOU HAVE ANY MORE SYMTOMS?

Nov 16, 2010 | 1995 Ford Thunderbird

1 Answer

RPM gage problem.


Replace the ignition module for the rpm and the spark control runs off this item

May 20, 2010 | 1995 Buick Regal

1 Answer

My speed gage is moving wierd it is getting stuck sometimes. Works fine at times then sometimes I will go about 50 and it will get **** and when I stop it is **** on 50, the rpm gage is also doing it


your vehicle has sensors located in the wheel hub that provide data to the speedometer/tach, possibly a bad sensor or if youve had brakes done recently, they may have been compromised during repairs---it is easy to test for with the corrrect diagnostic experts

Feb 22, 2010 | 2005 GMC Yukon

1 Answer

Changed alternator, now fuel gage needle is stuck


this happened because an electriacl surge. two ways to fix this.
1. remove the instrument cluster, then remove the clear lense, once the lense is removed you can use you finger to gently rotate the needles back into proper position. this sometimes works, if not
2. you'll need to send the instrument cluster in your local General Motors dealership and have them get a "advance exchange" instrument cluster. this is very expensive and you won't be able to drive the car until the cluster is back in the car.
I hope this helps.

Nov 03, 2009 | 1998 Oldsmobile Intrigue

1 Answer

97 grand am instrument cluster flicking


replace the gages their malfunctioning ,check the wires for they are grounded.

Jul 20, 2009 | 1997 Pontiac Grand Am

Not finding what you are looking for?
1998 Chevrolet K1500 Logo

Related Topics:

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...