An expert who has achieved level 3 by getting 1000 points
An expert that got 20 achievements.
An expert that got 10 achievements.
An expert that got 5 achievements.
Re: VW Passat 1.8T 1999
Do you mean at the bottom edge of the door? If so, open the door and down in the lower front corner on the inside you'll see a screw. Take that out - it's the locating screw for the trim piece. Then from the outside, slide the lower trim piece rearward to disengage its mounting clips, and it should come off in your hands.
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need. Goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Remove front door handle bezel screw cover
Remove inside handle bezel screw
Remove inside handle bezel
Lift upward on the rear of the front door inside handle bezel
Disconnect electrical connector
Remove handle screw cover Remove handle screw
Remove door trim panel upper screw
Remove door trim panel lower screw
Remove door trim panel (pull the door trim panel outward to release the pin-type retainers)Remove front door sail panel Disconnect mirror electrical connector
Remove 3 exterior mirror nuts and exterior mirror
SECTION 501-09: Rear View Mirrors
2003 Expedition/Navigator Workshop Manual
REMOVAL AND INSTALLATION
Removal and Installation
Remove the front door trim panel. For additional information, refer to Section 501-05 .
Front Door Trim Panel —Expedition
Removal and Installation NOTE: Left front door shown, right front similar.
Remove the door handle bezel.
Use service notch.
Remove the window control switch plate.
Use service notch and disconnect the electrical connectors.
CAUTION: To avoid damage to the door trim panel, lift the door trim panel by pulling directly upward on the armrest to disengage the panel clips. Remove the two bolts and three screws, and remove the door trim panel.
Remove the weather shield.
Disconnect the exterior mirror electrical connector.
Remove the exterior mirror.
Remove the nuts.
To install, reverse the removal procedure.
Install top nut first.
Exterior Mirror Motor
Removal and Installation
Position the mirror glass to obtain a gap at the top edge of the mirror and carefully pull the top edge of the glass away from the mirror housing.
Disconnect the heated mirror electrical connectors.
Remove the exterior mirror motor screws and exterior mirror motor.
alot of the times the plastic covers for the latch break and the plastic gets in the latch linkage and jams it up remove latch and look it over you will find the broken plastic just remove whats jamming it and reinstall
3 clips total. 2 on outside of light unit, to get to these you have to remove central trim from over boot latch, side trims and carpets, toolkit out, seats folded down, luggage blind removed, small trim piece inside wheel well removed (2 bolts 1 nut), then you can get up behind the light unit, gently clip the 2 outside (red) clips out till the light unit becomes free. to get to the third there is a black plastic trim piece clipped to the light unit where the boot comes down and meets it, this covers the third clip, gently pop it off and you will reveal the third clip and the nut needed to be removed to release it.