Question about 2003 Mercedes-Benz E-Class
Do you know how I could fix this problem, without taking it to the dealer? The red light displaying the message, stop, car too low, just came on yesterday after dropping my stepson off at football practice. It was squeaking the whole 20 minute ride home, and the last two minutes the message came on.
SOURCE: e320 reset SRS
Joe here to help,
Without going to a dealer, you need to get a scan tool to reset the srs light. Go to an Autozone store, They will scan it and reset it free of charge.
Posted on Apr 07, 2009
SOURCE: 2003 Mercedes benz e320 brakes
It is imperative that you loosen the caliper bleed screw BEFORE you push the piston back into the caliper. Failure to do so WILL damage the ABS hydraulics.
Posted on Apr 17, 2009
It is not complicated, depending on what hands-on level of DIY on car. Here are what need to do, so you can estimate how easy or hard when you look through your engine. Drain all the coolant, remove the thermostat housing, remove the fan, belt. Remove the water pump pulley. There are 4 bolts to hold the water pump in place.If you think you can take them out and put them in without removing the AC compressor then you can do it. I did it twice without removing the AC. The pump was fine for the second time, but for leaking seal. At dealer, it is easier to access from the bottom since they have a lifter. But it is doable at home. Have fun if you decide to do it.
Posted on Oct 11, 2009
SOURCE: crankshaft sensor Mercedes E320
i have mercedes 94 e320 was run ok .but after engine wash
first coil no sparking ,and a the second quit too ,running only whit the third coil ,,i changed all 3 coils but runnig a same,,no sparks on those front 2
Posted on Dec 14, 2010
Tips for a great answer:
Dec 12, 2012 | Mercedes-Benz Cars & Trucks
Nov 03, 2010 | 2005 Mercedes-Benz Mercedes Benz E320 Cdi
Dec 24, 2009 | 2005 Mercedes-Benz Mercedes Benz E320 Cdi
Jan 28, 2009 | 2005 Mercedes-Benz Mercedes Benz E320 Cdi
Dec 04, 2008 | 2005 Mercedes-Benz Mercedes Benz E320 Cdi
604 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: