Question about 1997 Dodge Intrepid

1 Answer

SAME STORY--INTREPID IN LIMP MODE

GATTING TROUBLE CODE 24-TPS SENSOR-BUT JUST REPLACED -I KNOW THE IAC IS STICKING ALSO-WOULD THIS PUT TRANNY IN LIMP MODE-THANKS

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 6,674 Answers

Double check for clean/good connections at TP sensor, then disconnect battery for a minute or so, to erase codes, and see if anything changes.

Posted on Nov 01, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My car keeps randomly going into limp mode


O2 sensors will do this and many times will not leave a trouble code.

Dec 04, 2014 | 2003 Dodge Stratus

2 Answers

2006 Sebring Touring 2.7


Check TPS sensor and IAC sensor.

May 08, 2013 | 2006 Chrysler Sebring 2.7

1 Answer

1990 chrysler new yorker will not shift into overdriver


You may have to have your ******/computer ran for any codes to give you a better idea of why it is limp mode. There are many causes of limp mode. A sensor or solenoid or bad wire will send the computer into limp mode. The TPS and map sensor both can affect limp mode

Jun 09, 2012 | 1990 Chrysler New Yorker

1 Answer

2004 dodge intrepid w/a 2.7. Check engine light came on and the engine started shuttering a mile away from home. Limped her home, and figured it was the cam shaft position sensor. (Had same symptoms in...


could be the T.P.S. sensor(throttle position sensor). It would be worth the money to have a free scan done by an auto parts store, as there are too many electrical problems that can happen, I.A.C. , M.A.P. and O2 sensors, also check to see if all the spark plugs are getting spark, if a plug isnt firing, then it will stutter lose power and could cause the gas odor because its not burning the fuel in that cylinder before it is exhausted.

May 08, 2012 | 2004 Dodge Intrepid

1 Answer

97 dodge intrepid, wont shift into any other gear but low. limp mode? changed comp, tranny, sensors, what could be causing thiis?


worn clutch plates, bad valve body, low fluid, input shaft drum scored, & or bad torque convertor

Mar 22, 2010 | 1997 Dodge Intrepid

1 Answer

On a 2001 dodge intrepid with a 2.7, whether you put it into drive or reverse it does nothing...this started when drivin on day it went into a limp mode...got it home and parked and when i later tried to...


limp mode as in computer limp in mode?check the trans fluid is it dark looking?, Need more info. Did you have the trans fluid changed recently? The reason i ask is when you change the trans fluid way after its do the new trans fluid is detergent type and fresh fluid can put the transmission in shock(Trans Shock). This can wipe out a transmission in 5 miles or so seen it too many times. Let me know how it goes. Lee

Jan 05, 2010 | 2001 Dodge Intrepid

1 Answer

Intrepid won't shift out of first gear, codes 0700, 0740, 0605


Your car most likely has gone into what is commonly called "limp in mode" The codes are transmission codes and you'll need to have it checked out and repaired. Something very common to Intrepids are the vehicle speed sensors going bad. If one or both go bad it will go into limp in mode and not shift properly. There is an input and an output speed sensor on these transmissions. Normally we would just change both because they are relatively inexpensive and easy to change. Hope that helps, gl.

Nov 24, 2009 | 2002 Dodge Intrepid

1 Answer

Blowing o2 sensor fuse and then not charging battery


Which fuse is blowing and When it goes into limp have you had it scanned for codes. If the TCM goes into limp then it will have a code in the computer memory.

Jun 17, 2009 | 1999 Dodge Intrepid

1 Answer

98 Intrepid Gone into "Limp Mode"


There are some sensors on the transmission that tend to go bad. You may also need to check the wiring. Could be a computer problem. How many miles?

Mar 06, 2009 | 1999 Dodge Intrepid

7 Answers

2002 Dodge Intrepid transmission not shifting


Flush out your transmission with the correct type fluid, Mopar ATF+4, and correct filter. Disconnect Negative cable, to reset computer, for at least 24 hours. Check grounding straps for PCM, ensure they are tight and clean.
This method worked on my 2003 Intrepid SE, 3.5L, Police Pkg car.
Good Luck!!

Jun 27, 2008 | 1997 Dodge Intrepid

Not finding what you are looking for?
1997 Dodge Intrepid Logo

Related Topics:

190 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...