1999 Mitsubishi Galant Logo
Anonymous Posted on Jul 14, 2011

Mitsubishi Galan 1999, When I started driving it today it was smooth, drove just 2 minutes and suddenly car started stuttering and Service Engine Light came up. Now when I start car the voice is good but when I put in the gear and give acceleration it stutters. The sound is not good and car has little vibration. What could be wrong?

2 Answers

Reynaldo Andico

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Mitsubishi Master 2,431 Answers
  • Posted on Jul 14, 2011
Reynaldo Andico
Mitsubishi Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Apr 21, 2011
Answers
2431
Questions
0
Helped
1235641
Points
7940

You have a misfire under load the fix will require a coil plug wire and sparkplugs

  • Anonymous Jul 14, 2011

    cansmo, should I drive to mechanic or tow it?

  • Reynaldo Andico
    Reynaldo Andico Jul 14, 2011

    The main purpose of the check engine light for all cars is to protect the catalytic, becuase you are misfire under load its up to the car and how badly your misfire is if you are less than 12 miles go ahead and drive the vehicle.

×

Anonymous

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Master 1,623 Answers
  • Posted on Jul 14, 2011
Anonymous
Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: May 06, 2009
Answers
1623
Questions
0
Helped
829065
Points
7074

The engine management system has been alerted by one or more sensors of a malfunction and that has caused it to turn the service light on. It could be a number of things that caused it, but without knowing why, we would only be guessing. You need to have an OBD II diagnostic scan run on your Galant to determine what DTC codes have been set by the engine computer. If you can do that, and report back here with the code numbers i will continue to help, but we need those codes.

A typical code will be 2-3 letters letters followed by 2-3 numbers.... P0401 for example.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

What does the MIL code "PO 320" mean, please?

code p0320 refers to cam shaft position (CKP) sensor/engine speed (RPM) sensor--circuit malfunction=== causes --wiring--CKP/RPM sensor ---ECM
because the engine runs ok until it is on cruise control I would be investigating the RPM sensor for a fault
The cruise control takes its control from the RPM sensor and if that circuit is interminable the the cruise control doesn't know what rpms to maintain.
0helpful
1answer

My 04 Ranger Edge dropped speed and the a/c stopped working while driving on the Interstate. The road is smooth, 91degrees, and had been running for about 1 hour after fill up. I pulled off the road, shut...

Make sure your system is charged properly. Also make sure your cooling system is properly clean and filled up to max levels. Sometimes low freon or old cooling system fluid will cause a delay in the A/C to work. Also chech to see if there is any black powder around your A/C clutch, if so, this is a sign that the system is about to go out of service. You can get a great deal on the part from Amazon.
0helpful
1answer

I have esteem car model 1999 my car is smooth running sudden engine stop , enging not start again and after 3 minutes engine will be start so what is the problem plz tell me

which of the 2 engines, 1.6L or 1.8l, (radically different)?????
engine stalls.
top cause, no service, a tuneups skipped, ever do the 60k tuneup?
per the operators guide?
if it dont start, for 3 mins.
its either
1: flooded (use WOT cranking to unflood any engine)
2: lost spark,. do the std, spark tests.
3: plugs fouled (tuneup?)
4: lost fueling.. no fueling at all and TEST FUEL (spraycan) works for 3min run and dies, sure lost fuel.


1helpful
2answers
0helpful
1answer

Electrical problems with 2006 Nissan maxima

I would start with checking the computer for trouble codes.
Sounds like a bad connection in the dash wiring or key switch, but the trouble code might steer you in the right direction.
0helpful
1answer

When i push the gas it stalls and stutters

Disconnect the battery and let the computer reset. Do the issues go away? If so, then it is related to something that the computer is learning during driving. Narrowing that down can take a LONG time, even for a certified automobile technician.
0helpful
1answer
0helpful
2answers

LR discoII 1999,shuts down on the road with Engine service+batter

Change your battery terminals.

http://carservicemanuals.blogspot.com/2008/06/download-land-rover-discovery-workshop.html
Not finding what you are looking for?

245 views

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...