My driver's side power window switch doesn't work. All the other window switches work fine.The switch was not acting up at all, it worked great in the morning and that night when I was going home I went to use the switch and nothing happened. If I hold down the switch I can hear a clicking sound in the switch,Can I change just the driver's switch or is it one complete unit?
I had the same problem...it was the window gear that got stuck when the window was all the way up. (that's the clicking) I took my panel off and banged on the inside of the door with a rubber mallet. The window works again. Since then I make sure when I role the window all the way up to stop that I just barely tap the down button to release the pressure on the gear inside. When your using the hammer...hold the switch in the down mode...ignition on of course.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
If your fuses are good, perhaps your heated seat switch is faulty. You can test the switch for connectivity using a meter to see if power is going through the switch when in the ON position. If the meter shows no power while in the ON position, replace the switch. If power is reaching the seat, then likely the heating element itself within the seat is the culprit.
Inspect or replace the window lock and unlock switch on the drivers door power window switch. There is a lock and unlock switch that will disable the switches to the other power window in the Jimmy. Check to make sure that switch is in the unlock position to have the other power window switch to work.
Thank you for suing fixya and good luck.
Left side of the dash, to the right of the IP fuse block. Its a 25 amp circuit breaker, an aluminum cased breaker.
CHECK FOR POWER ON THE SEAT SWITCH "A" TERMINAL AND GROUND ON THE "D" TERMINAL. IF YOU HAVE POWER AND GROUND THE SWITCH IS BAD.
The same thing happened to my 1999 JMC Jimmy recently. I believe the problem is that your power window motor has most likely gone out or is starting to go out. The motor will need replaced. They are pretty expensive new. I went to a junkyard and got one for around 15 dollars. When mine went bad, I had rolled my window down about three or four inches and it stuck there. I took my door panel off and tapped on the motor while holding up on the window switch and got it to go up after a few minutes. I am replacing my motor today, I'll leave an update here about the outcome when I finish the job. I hope this information helps you.