Question about 1999 Chevrolet Malibu

1 Answer

Transmition wont go into gear.

The automatic transmition wont go into gear untill it is warmed up and then when going up hills, the RPM's rev high and there is no power. I was told it is the "manual shifter modulator" any idea if it is true, if so how do I replace the sensor.

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 19 Answers

Is the transmission fluid at the correct level?

Posted on Aug 26, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Transmission wont shift right after engine warms up

I would recommend a transmition fluid change first , the fluid in a automatic gearbox has a best by date shall we say and after that will cause all sorts of issues mostly with the gear change

Nov 27, 2016 | Cars & Trucks

1 Answer

Where is the rev sensor on a 2001 ford ranger

You would most likely find it on the tail shaft housing on your transmition. That is towards the rear of the transmition near where the drive shaft enters the transmition. The sensor will have a 3 wire conector on it. It does not matter if it is a manual or automatic.

Aug 17, 2012 | 2001 Ford Ranger Regular Cab

1 Answer


When is the last time you checked your transmission fluid? If it's low it could help to add some, but I hate to tell you it sounds like it's on the way out.

Nov 12, 2011 | 2005 Ford Mustang

1 Answer

My 2001 hyundai sonata will not start it turns but never catches i had a mechanic look at it and i got a P0335 come up but i don't know what to do with it aswell as the transmition is always looking to...

p0335 is fault code for crankshaft position sensor which is why it wont start
you may well have to have this done in order for the mechanic to diagnose your transmition fault. it's a bit of a "catch22" situation, you should ask mechanic for worst case with transmition fault regards price and decide weather you want to repair or not

Jun 12, 2010 | Cars & Trucks

1 Answer

Speedometer don't work as well as automatic transmition

Check with a DRB scan tool to see if the transmission is seeing input and output speed, as these sensors were very common to fail.

Sep 10, 2009 | 1999 Chrysler Sebring

1 Answer

Transmition problem

No forward or reverse? After you installed it how much fluid were you able to get in it before it read full?

May 27, 2009 | 1997 Dodge Dakota

2 Answers

Transmition wont shift

Sounds like a bad toque convertor or a bad front pump

May 23, 2009 | 1998 Ford Explorer

3 Answers

Automatic Transmition Wont Shift automaticly

sounds like the governer gear stripped out , its located on the driver side on the trans where the axle inboard shaft goes into the trans

Dec 19, 2008 | 1989 Toyota Camry

Not finding what you are looking for?
1999 Chevrolet Malibu Logo

Related Topics:

125 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

77932 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides