Question about 1991 Mazda 323

1 Answer

Spoiler need to find a new spoiler

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have a rear spoiler for a 91 mazda protoge 4 door.

Posted on Dec 06, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

02 Mitsubishi lancer won't start. Leaking antifreeze thru .spoiler pipe


Why is there a spoiler pipe.... Or do you mean exhaust pipe... If you mean exhaust pipe then that means that your engine is in desperate need of new seals or it is blown.. Either way its a pain to fix :'(

Oct 28, 2014 | Cars & Trucks

1 Answer

How to replace 3rd brake lite chrysler pacific


1.Open liftgate before disconnecting battery.
2.Open hood, disconnect and isolate the battery negative cable.
3.Open liftgate.
4.Disconnect the power liftgate prop rod.
5.Remove liftgate trim panel
6.Remove the four retaining nuts to spoiler .
7.Gently lift spoiler off of outer liftgate panel.
8.Disconnect the CHMSL electrical connector.
9.Disconnect the washer hose.
10.Remove spoiler from vehicle.
11.If replacing spoiler, transfer CHMSL lamp to new spoiler.
12.If replacing spoiler, transfer washer nozzle to new spoiler.


replace-3rd-brake-lite-chrysler-pacific-gforj5atjwvxe3vijclvf5dv-1-0.png

Aug 31, 2014 | Chrysler Pacifica Cars & Trucks

1 Answer

Spoiler, would it effect the car if we took out the two fuses to it? We think the spoiler isn't closing every time and causing the battery to drain.


have you checked that alternator is charging correctly? this would be my first step for new battery going flat

Mar 30, 2014 | Volkswagen Cars & Trucks

1 Answer

My brake lights on the spoiler of my 2004 Lincoln LS do not work.


lift the car and lock inside of the spoiler turn the conector and pull out the light bulb and instal the new bulb light

Jul 22, 2012 | 2004 Lincoln LS

1 Answer

How to install a spoiler for 2001 chevy impala


If the spoiler has mounting studs then holes will need to be drilled into the trunk lid so that the spoiler can be bolted on from inside. You must figure out where to drill the holes so that the spoiler will be centered on the trunk lid. One method is to apply shoe polish or machinist dye to the end of the mounting studs. carefully place the spoiler onto the deck lid where you would like it to be. Press straight down and then lift it straight off with one motion. The spots that are left behind is where the holes should be drilled. The holes can be enlarged slightly to allow for final adjustment. Use spacers between the spoiler and the deck lid to keep the paint from being damaged when closing the trunk lid.

May 16, 2011 | Chevrolet Impala Cars & Trucks

3 Answers

How do you take off 2004 Ford Taurus rear spoiler wings?


You'll need to open the trunk and remove the trim along the top of the trunk. The trim will be secured by some screws that should be along the perimeter of the trim. Once the screws are out, gently pop the trim off (there will be retaining clips that you don't want to break) and then you can access the bolts securing the spoiler onto the trunk. If you plan to not use a spoiler, you will need to find something to plug up the holes to prevent water and dust from getting into the trunk.

Oct 21, 2009 | 2004 Ford Taurus

1 Answer

2007 Corolla S, Spoiler break lights out


you will find the complete lamp needs to be replaced it usually is screwed in from the front of the rear spoiler but differs from spoiler to spoiler

May 12, 2009 | 2007 Toyota Corolla

1 Answer

How do you replace the brake light on the rear spoiler on a 2001 Hyundai Accent?


This is the Spoiler Dude. The spoiler light is attached with screws to the spoiler. You must remove the screws and then the spoiler light will come away from the spoiler. Clip the two wires ( Black & Red ). Attached the new spoiler light ( I can get that for you) with a sleeve. Test the new light with the brake pedal depressed. Screw in the new light and that is it. If you have any questions.
Call Spoiler Dude Paul
719-661-8600
www.spoilerdudepaul@gmail.com

Apr 20, 2009 | 2001 Hyundai Accent

3 Answers

Can't get the spoiler, that holds the 3rd brake light on the off


regarding chevy equinox spoiler there are three 10mm bolts one on each end and one in the middle then there are three pins in the middle that snap in. these are very difficult to release without breaking them. If they break use a two part adhesive sparingly to hold the spoiler down or it will hit when you open the hatch.

Apr 05, 2009 | 2005 Chevrolet Equinox

1 Answer

Ford ka rear spoiler


You need to look on under side of spoiler, and match studs. (two way threaded bolts) to the wholes. after that mark where the stud wholes need to go through the trunk then drill wholes a 16th bigger than the studs. After drilling wholes through the trunk get sillicone sealer around wholes. Install spoiler and install bolts on the underside of your trunk.

Jul 02, 2008 | 2002 Ford Escort

Not finding what you are looking for?
1991 Mazda 323 Logo

Related Topics:

217 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...