Re: Where is the computer in a 1995 Ford Contour.Also...
Either under hood on passenger side firewall or behind dash on passenger side. Obd port is under hood usually on pass side near firewall. 96 and never vehicles, its under steering column.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
According to the Ford OBD code list for your car, it is "Additional Fan Relay Circuit Malfunction." I would check the fan relay and all connections to it. If you can't find anything there, then I would guess it's probably a wiring issue somewhere.
Are you trying to hook up an OBD II code reader? if so then your car is not OBD II compliant. You need a GM OBD I scan tool. If it just isn't "talking" to the computer, then check for a blown fuse. usualy the fuse that controls the aux power/Cig lighhter is the same one.
YEP LOOK UNDER THE HOOD IN THE ENGINE COMPARTMENT IN THE FRONT LEFT STRUT TOWER.YOU HAVE A DIAGNOSTIC TERMINAL.YOU CAN USE A SCANNER OR USE THE ANALOG VOLT METER WITH THE KEY ON ENGINE OFF.YOU NEED A MANUAL TO SEE HOW TO HOOK VOLT METER TO SELF TEST DIAGNOSTIC TERMINAL ON STRUT TOWER.BE EASIER TO USE CODE SCANNER WITH FORD HOOK UP ADAPTERS.
this code indicates a problem with the transmission range selected switch, this switch is on the transmission case where the shift cable attaches, when u select a gear it sends a signal to the computer control that u want lets say Reverse by sensing the range selector switch feedback, replace the switch will most likely cure the code, then clear the code and drive a few miles.
I was reading in one of my repair manuals and it says in there that there could be a block where the exhaust gas pressure sensor is. There could be a blocked inlet hose. Or it could be the ECM.
i know this post is old but 1996 and newer is obd2 and is under the dash but 1993-1995 is obd1 and is under the hood on passenger side hooked to part of the wiring harnes by the computer.
×