Question about Ford Crown Victoria

2 Answers

1997 FORD/CROWN VIC STEERING IS BINDING LEFT AND RIGHT TURNS

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Check u joint on stering shaft under hood they bind up after sitting i heated them up and soaked to free up.

Posted on Aug 29, 2008

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 74 Answers

Fluid low?aeriated pump? bad pump?turn wheel running all t he way to stops eachway several times to purge air

Posted on Aug 26, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1997 V8 4.6l. It turns over, but why won't it start?


Part 1 -How to Test the Starter Motor (Ford 4.6L, 5.4L)

troubleshootmyvehicle.com > Ford > 4.6L, 5.4L
Mar 2, 2011 - Page 1 of 3: How to test a BAD Starter (Ford 4.6L and 5.4L Pick Up and SUV). ... a BAD starter motor on your 4.6L or 5.4L V8 equipped car, pick up or SUV. ...and will turn over the engine; -OR-; The starter motor won't do a thing. ... Crown Victoria ... 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005.

Question: 1997 Crown Victoria Lx Cant Turn on and Cant ...

www.2carpros.com/.../question-1997-crown-victoria-lx-cant-turn-on-an...
May 26, 2014 - Ok so i put the keys in the car turn the key but seems to me it moves more ... 1997 Ford Crown Victoria • 4.6L V8 RWD Automatic • 99,625 miles ... Keywon't turn off accessories or turn car over and ignition cylinder turns too ...

Oct 19, 2015 | Ford Crown Victoria Cars & Trucks

1 Answer

1997 CROWN VIC I need a fuse box diagram for the "under dash" fuse box. Do you have one?


Hello! Go to the following link for a diagram of a 1995 crown vic...Same as 1997...Guru...Saailer



http://www.supermotors.net/registry/media/254296_1

Aug 24, 2011 | 1997 Ford Crown Victoria

2 Answers

1985 ford crown vic ltd 352 200k miles been running good burns NO oil.\r\ndriving at night engine shuts down. I turn lights off, wiggle turn signal switch and it starts again. Once I was making a right...


I dont see if the turn signal light has to do any thing with the engine shutting off, make sure the IAC idle air control valve is working, air filter is good, fuel filter is good and IF your vehicle has a power steering pressure switch then that could be causing it but with 1985 Crown Vic I dout it.

Feb 27, 2011 | 1991 Ford LTD Crown Victoria

3 Answers

My steering wheel is really sticky when im making turns i throught it needed power steering fluid but that wasn't the case. Can anybody tell me what could it be?


Its the steering arm, under the hood drivers side, it connects the steering column shaft to the steering gear box. The small universals get really rusty. causes it to bind. don't try to lube them it doesn't work. About $50.00 from ford.

Feb 12, 2011 | 2001 Ford Crown Victoria

1 Answer

97 Crown Vic transmission issue


Check the transmission linkage cable that runs from the steering column under the dash to the trans under the car. make sure that the cable is not damaged and that all connections are tight.

Jan 05, 2010 | 1997 Ford Crown Victoria

1 Answer

99 crown vic police interceptor steering wheel??


i have ran into 2 issues in these vehicles---if it binds while sitting still also, check the steering shaft, i have found the u-joints in the shaft tighten up and binds dangerously tight---if they are free, sounds like you may have a steering box issue or restriction in a line---hope this was helpful!!

Jul 07, 2009 | 1999 Ford Crown Victoria

1 Answer

Key will noot turn in the switch


try turning the steering wheel left and right while turning the key, sometimes when you park with your wheels turned it will lock the wheel and key. you may have to put a little force into turning the wheel, nothing that will make u sweat... hope this helps you and good luck!!!

May 22, 2009 | 1999 Ford Crown Victoria

1 Answer

Pulsing feel to right in steering wheel on hard left-hand turns.


What rims are on the car the steel police ones and what tires are on it could be hitting the stops on the frame and where the proper bolts put back in on the rack mounts and did you go with the heavy rack for the police car .Cause when I built them there was an issue with the proper bolts and there was a different rack for the cop cars the to the basic crown vic do to the suspension upgrade on it and the diffrent pump

Mar 12, 2009 | 2003 Ford Crown Victoria

1 Answer

2003 ford crown vic hard steering


i would have to say to check for a relay in your fuse boxes for power steering pressre switch or it may have its own police pkgs have a lot of relays due to all the extras

Sep 10, 2008 | 2003 Ford Crown Victoria

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

104 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...