Question about Pontiac Vibe

1 Answer

When you try turning on air flow nothing comes out.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 422 Answers

Either a bad fan switch or the resistor is bad either way its best to replace both, but first check your fuses

Posted on Aug 26, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Temperature gauge on max,very little heat coming thorough heater system


check your heater core and your thermostat. your thermostat first.

Feb 18, 2015 | 2005 Mini Cooper

1 Answer

2010 Toyota corolla isn't blowing any air heat or defrost. The switch won't turn anything on. There is a constant air flowing very very lightly thru vent and u can hear fan running but switch cobtrols...


Hi, the switch has a cable connected to it, it has definitely come loose from the plastic housing that controls the air flow,suggest open out the panel and reconnect the cable.

Nov 13, 2014 | 2010 Toyota Corolla

1 Answer

A/C system cooling deteriorates over time


Had a similar thing happen to me, recharged the system and have not had it happen since, note that you should make sure you get a recharger with a long hose, the recharge port is low behind the radiator. It occurred on mine at the beginning of summer.

Jul 19, 2013 | 2008 Buick Enclave

1 Answer

When turn on air it only directs the air flow to your feet and turn switch to other positions it does nothing as per to direct air in those positions.


Sounds like you have lost vacuum in the engine bay,a broken vacuum hose? Most air flow control is done with vacuum operated dampers

Oct 11, 2010 | 1995 Pontiac Grand Prix

1 Answer

Just had my oil changed and now I have a service engine soon light that will not go out


Most likely the air flow sensor was left of the intake hose going from the air filter housing to the air intake of your motor. Also the light may come on if the sensor was released while the key was turned on but the engine was turned off. If you can take a look under your hood and look for the air filter housing. Once you find it follow the Large air hose that goes into the motor. On this hose there should be a sensor plug in for the air flow sensor wire. If there is nothing plugged into try to locate the wire and plug it in. Once you have it plugged in or if it was plugged in try disconnecting your positive battery cable for about 10 minutes to reset the check engine light. Be careful when disconnecting the battery not to touch any metal with the end of your wrench or ratchet. Hope this works for you..

Apr 19, 2010 | 2000 Buick LeSabre

1 Answer

My subaru impreza 2.0 turbo AWD engine has cut out 3 time in the last couple of weeks! the engine just dies no warning lights come on and after a while it restarts as if nothing wrong! no unusual noises...


Could be an air flow fault, check all your air pipes for holes or splits and also check the air flow meter and sensor. just clean them up before going any further.

Also check the earth lead from the battery to the slam panel, and to the gearbox make sure all the earths have a good contact to the car body.

Jan 22, 2010 | 2000 Subaru Impreza

1 Answer

Engine power reduceed


clean the throttle body and replace the mass air flow sensor a know good one and see if that fixes it if it does you found your problem. normally the mass air flow sensor would cause the rig to run crappy atany speed.

Jun 25, 2009 | 2004 Chevrolet Silverado 1500 Crew Cab

1 Answer

Turn the knob for vents & ac but no air comes out?


Check to see if the plastic knob has been stripped. Pull off the plastic knob and see if just turning the metal underneath makes a difference.

Jun 03, 2009 | 1999 Acura TL

1 Answer

Car does not blow air.


For starters, do you hear the blower motor running when you turn the heat on? If it does blow is there any airflow coming from your air vents? If the blower motor runs and there is air flow from the vents there are a few other tiems to check. Veriiffy that the coolant is full, low coolant level will effect the flow of coolant to the heater core. If coolant is full you may have a clogged heater core, or one of the blend doors ( they regulate air flow between the A/C evaperator and your heater core) may be malfunctioning or the control head(temp control) is malfntioning.

Jan 13, 2009 | Hyundai Motor 2003 Sonata

1 Answer

Air flow 2001 Grand Am


the mix doors in the heater assembly arent opening and closing right

Oct 27, 2008 | 2001 Pontiac Grand Am SE

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

96 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...