Question about 1995 Dodge Neon

1 Answer

Ricardo_m_guillen@hotmail.com How I can disconnect the alarm of my NEON 95? Lost the control. Best Regards!!!!!

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 752 Answers

Due to the sensitive nature of the cars computer systems, it is best left to a professional, But basically if you're set on doing it yourself, just look for the brainbox of it. It is usually under the steering column area and will look quite out of place (assuming it's an aftermarket alarm), as it will have a multitude of wires of various colors coming out in all directions. Just disconnect the harnesses from the brain and you should be good. If it has two wires labeled something like "Starter-key side" and "Starter- Motor side" you will need to join these together or your car will not start anymore.

Posted on Aug 25, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Neon 95 speed sencer diagram


95 dodge neon speed sensor ?!?!?! - Discussion on Topix

www.topix.com > Dodge Neon
Jul 28, 2006 - My 95 dodge neon brake pedal sinks somewhat on putting the brakes ... the speed sensor is located in the middle near the fire wall. just to the ... 1998 Neon + Speedometer
Mar 19, 2007
broken speedometer 95 neon
Jan 22, 2007
96 neon cranks but wont turn over
Oct 29, 2006
More results from www.topix.com

How To Install Replace Speedometer Input Sensor Chrysler ...

? 3:05
www.youtube.com/watch?v=y6bwJKFT6aY

Oct 31, 2013 - Uploaded by 1A Auto Parts
How To Install Replace Speedometer Input Sensor ChryslerDodge Automatic ... it with a 1A Auto Automatic ...

Oct 31, 2015 | Cars & Trucks

1 Answer

How to disable or bypass viper alarm on 95 Honda accord


Older aftermarket alarms can be a real problem. The best thing to do is completely remove it from your car. This isn't too hard, it just takes a little time, I usually charge 1 hour to do it. Locate and remove the control units and disconnect all wires tied into the factory harnesses. Wrap up any exposed wires with electrical tape and reattach any cut wires and wrap up. Take everything out, siren, wires, etc and you will be better off.

Feb 28, 2015 | 1995 Honda Accord

1 Answer

How to bypass alarm


don't know if you can but you can try resetting everything. you disconnect your battery for 10 mins (positive post on battery) then reconnect it then start your car.

May 07, 2014 | 2004 Dodge Neon

1 Answer

95 neon shuts off after 20 mins of runing


Hi Robert, I suggest taking the vehicle for a diagnostic scan. It sounds as though the fault reappears after the vehicle reaches operating temperature and therefore could be something to do with the air flow sensor or the management system (But the latter is not likely) Regards John

Jun 24, 2012 | 1995 Dodge Neon

3 Answers

I disconnected battery cables on small suv to clean them. After reattaching, I noticed rear window on tailgate went down about 8 inches. I then raised window by button on dash. It closed for a moment and...


its lost its memory ,hold key in lock and close window then holding key in closed position for 10 secs should reset the memory in the electronic control box on the window motor memory inside this control box

Dec 19, 2011 | 2002 Land Rover Freelander

1 Answer

Car will *** on but will not turn over due to alarm installation


Simplest way is to remove the alarm. If it's too much of a hassle, have the wires that lead from the ignition to the alarm control unit disconnected. Otherwise, keep a screwdriver handy and jump the terminals on the solenoid when you need to start it up.

Jul 08, 2009 | 2005 Dodge Neon

1 Answer

Replace alternator for a Plymoth NEON


the alternator for a 95 neon

1 first take the right tire off
2 then lift the car
3 then get a 15mm socket and loosen the blots of the bracket
4 then open the hood and undo the power steering and take off the top bot of the alternator
5 then take off the bottom blots and take off the bracket
6 then move the alternator so you can disconnect the wiring i think you need a 10mm for that maybe smaller
7 then pull it out(when i did it to mine it was hard to pull it out)
8 then to put it back just the same way but backwards

mine broke too if you need more help email me ozark99@hotmail .com

Mar 28, 2009 | 1995 Plymouth Neon

1 Answer

1990 Honda prelude


I did. I sent some diagrams.

Oct 20, 2008 | 1990 Honda Prelude

1 Answer

Ricardo_m_guillen@hotmail.com


When I accidently set of the alarm on my 97 Jetta, I had to lock and then unlock the drivers side door(passenger side works too). This shuts off the alarm.

Aug 25, 2008 | 1995 Dodge Neon

2 Answers

My 95 dodge neon batter wont jkeep a charge


Check the accessory belt tension. The belt should move 1/4 to 1/2 inch when you push on it. The alternator belt is closer to the firewall on a 96 neon. Also for a temporary fix until you figure out the problem get a solar charger that plugs into your cigarette lighter. Other possible causes; bad battery cables or connections. Check all connections are clean and tight (check both ends at the battery and at the starter and ground wire. Caution always remove negative battery first and replace last.

Aug 05, 2008 | 1995 Dodge Neon

Not finding what you are looking for?
1995 Dodge Neon Logo

Related Topics:

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...