Question about 1996 Chrysler Sebring

1 Answer

Replacing headlight in 1996 Chrysler Sebring JXI

How do I replace the headlights in a 1996 Chrysler Sebring JXI?

Posted by on

  • 4 more comments 
  • Anonymous Mar 20, 2014

    2.5 engine overheated on 2000 sebring conv.jxi and can see antifreeze leaking from rear of block,is this the freeze plug and how to repair or replace it. thank you

  • Anonymous Mar 21, 2014

    replace blend door actuator

  • Anonymous Mar 22, 2014

    problem started after sub zero cold start

  • Anonymous Mar 23, 2014

    replacing coil pack on cylinder # 1

  • Anonymous Mar 25, 2014

    The radiator is pluged and needs to be flushed or replaced.

  • Anonymous Mar 31, 2014

    I just bought a 2003 Chrysler Sebring and can't find the switch to turn on the headlights



1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Piece of cake....
take off the two "star" bolts, one toward the center of the engine above the light assembly and the other toward the fender (it is very long). when you remove them both the entier assembly falls off into your hands and makes changing the bulbs much easier.

Posted on Sep 16, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Somehow my camshafts were moved while replacing timing belt. Best way to recover? 96 Sebring jxi 2.5 v6 HELP!!!!

the engine has been identified as an intereference engine and that means every possibility of valve damage
to recover , loosen of the valve adjusters or loosen of the cam shaft caps so that the valves are all closed before you rotate the crankshaft to TDC
then reset the cam shaft/s timing marks and do it all back up and hope that no valves are bent

Sep 18, 2016 | 1996 Chrysler Sebring

1 Answer

Where is the fuel filter on a 1996 chrysler sebring convertable jxi

Inside of the fuel tank. Everything is together as a unit...your fuel pump, fuel pressure regulator, and fuel filter.

Feb 11, 2016 | 1996 Chrysler Sebring

1 Answer

Chrysler Sebring 2008 headlight assembly removal

some times headlamp units have a plastic retaining clip on the underside of headlamp, does the headlight move from side to side? try to pull the headlight back from the top of unit then lift up the headlamp unit, if not it could be the headlamp adjusters holding unit in place.

Dec 06, 2013 | 2008 Chrysler Sebring

2 Answers

Headlights stay on even when the light switch and car are off.

try replacing the light switch in thecar sounds like its faulty

Feb 27, 2013 | 2008 Chrysler Sebring

1 Answer

My 1996 chrysler sebring jxi convertible is shut down by the anti-theft system and won't start

tfit8 was correct...I have a 1996 Sebring JXi convertible, I had the exact same problem, I googled it, and that's exactly what worked...resetting the alarm system by locking and unlocking everything, including the truck, with my key

Aug 11, 2012 | Chrysler Sebring Cars & Trucks

1 Answer

2005 chrysler sebring convertible~ low beams not working, but all other lights do~ checked fuses and they llok fine...any ideas?

, try using a voltmeter on the plug for the bad headlights Turn on the ignition, and turn the headlight switch. If the voltmeter shows no voltage, then either your switch or the wiring leading to the headlight has gone bad.If replacing your headlight switch does not solve the problem, then there is a break in the wiring leading to the headlight, and the wiring will need to be replaced. also check to see if you have a relay for the low beams in fuse and relay box, check this first !

Jan 24, 2012 | 2005 Chrysler Sebring Conv

2 Answers

Replacing headlight bulbs on a 2006 chrysler sebring

Behind the headlight you should see a eletrical wires running to the headlight section. There will be a 2 inch round plastic ring. You grap the back of the bulb and turn it to the right which will release the bulb and the socket. You pull out the bulb and replace it the same way. If this doesnt help then get back to me.

Feb 06, 2009 | 2006 Chrysler Sebring

Not finding what you are looking for?
1996 Chrysler Sebring Logo

496 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers


Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides