Question about 1993 Nissan Altima

1 Answer

BRAKE LIGHTS My 1993 Nissan Altima brake lights stay on all the time , I have remove the brake light switch and thier still on any ideas

Posted by on

  • fdukes30 Sep 28, 2008

    my nissan altima has the same problem, i have checked all fuses, bulbs, and wiring that was accessible. i also checked the switch the brake pedal pushes on when u push the brakes, all checks out good but the brake lights stay on but the drive side brake lights wont come on period? any solutions would be greatly appreciated

  • Anonymous Nov 02, 2008

    I have the same problem. I found broken bits of plastic on the floor. But the button is being pushed in when the pedal is unpressed.

×

1 Answer

Theres a rubber stop on the break pedal
once they get old the crack & break
you can use a nut & blot to replace the rubber stop

Posted on Sep 03, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1996 nissan altima brake lights stay on


disconnect your brake light switch ,its in brake pedal once you disconnect ,brake light off,either swicht or grounded to other wire

Jul 21, 2012 | 1996 Nissan Altima

1 Answer

1996 nissan altima brake lights stay on


there is a pressure switch under ur break pedal.it might come off happend on my altima i snapped in a penny and it solved it.switch needs to be pressed in inorder to turn the brake light off.good luck..

May 19, 2012 | 1996 Nissan Altima

1 Answer

Why does my brake lights stay on????


Check your brake light switch that is attached to your brake pedal arm under the dash and make sure it is in its bracket and the pedal arm is operating the switch open and closed when you push the pedal and release it

Jul 22, 2011 | 1993 Nissan Altima

1 Answer

Brake lights stay on all the time . Checked brake pedal switch and it closes and opens as per reading on ohm metter, brake lights continue to stay on even when I short out brake switch connector.


This is the diagram. If you disconnect the switch, do they stay on? If so, you have another circuit feeding it (i.e. new radio or alarm installed maybe?)

0900c15280265691.gif

Dec 19, 2010 | 1995 Nissan Altima

1 Answer

Emergeny brake light stays on. Hoe do I remove the consolr to replace emergency brake switch


actually barry before i pulled out the console i think i would take a long look at the pedal or lever which you push or pull to put the brake on. I'll bet you find a button switch attached to it somewhere, which completes a circuit and supplies 12 volts to a light in the console. However I could be wrong and a look through a manual could set you straight before you turn a wrench


http://cgi.ebay.com/ebaymotors/Haynes-Repair-Manual-Nissan-Altima-1993-2006-/230556747466?pt=Motors_Manuals_Literature&hash=item35ae40c6ca

Dec 02, 2010 | 1993 Nissan Altima

1 Answer

I have a 1993 Altima...have replaced brake switch and my brake lights still stay on ..WHY?


maybe the relay is shorted on. Pull out the relay and troubleshoot the socket.

Please see my tip at http://www.fixya.com/cars/r6022358-relay_check and let me know if you have questions.

Sep 22, 2010 | 1993 Nissan Altima

2 Answers

Brake lights will not turn off on my 94 Nissan Altima


Your problem should be that the rubber stops that are mounted at the top of your break pedal came out or are worn down too much to press the buttons all the way in.
What they do is push the button that switches off your break lights when the break pedal is released (yes, kind of backwards way to design it, i know). That's why your lights stay on even when your car is off. I had to go to the junkyard to find replacements for mine and they are a ***** to replace.
They are chipped away easily by the break switches when your car shakes badly over a prolonged period of time. Like driving a couple of weeks on a bad front tire.

Dec 05, 2009 | 1994 Nissan Altima

1 Answer

Brake lights stays on


You need to adjust those nuts so that it goes out. Back it off, so that switch moves away from pedal. leave some clearance, very slight, between plunger & where it makes contact. Then tighten both nuts to keep it in place.Not too much clearance, just enough that lights go out.

Feb 01, 2009 | 1993 Nissan Altima

1 Answer

1996 nissan altima Brake lite no funtioning


check ground screws in plastic housing where light bulbs are in rear lights

Nov 15, 2008 | 1993 Nissan Altima

2 Answers

Nissan Altima 1995 Brake Light swith staying on


I know this is outdated but for those with this problem which i had too, it is a rubber stopper that attaches to the brake pedel itself to keep the switch depressed on my car for there is 2 switches and there is 2 rubber stops attached to the brake pedal. this being gone will cause the brake lights to stay on all the time.

Aug 08, 2008 | 1995 Nissan Altima

Not finding what you are looking for?
1993 Nissan Altima Logo

231 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...