2000 Celica making grinding noice from right front wheel.
2000 Celica making grinding noise from right front wheel.Sounds like bearings or something.I took the wheel off and the rotor and caliper shakes.The other side didn’t and the faster the louder the noise. The only thing I can think of is a ball bearing assembly; I know nothing else about it. I need to know what to replace.I can’t find a repair book for a 2000 Celica any ware.I can find for 1999 and earlier but not 2000.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
You should definitely pull the front wheel and check the bearings (they are roller bearings, not ball bearings). With the wheel off, you should be able to isolate where the noise is coming from, but I vote for the bearings. Check, replace and/or repack, and adjust properly. If you have noise, you should be able to feel the "play" in the bearings, or see the wear problem on the spindle and bearings. I hope this helps you.
a) a brake disc shield is too close to the disc, and it's coming into contact in the circumstances you outline
b) pebbles stuck between the disc shield and the disk
c) dried out wheel bearings
d) worn Universal Joints in the drive shafts
e) worn A/C pump
f) worn alternator
g) worn water pump
Is the noise still present above 15 miles an hour and past 1500 rpm when the clutch is disengaged (i.e. gearbox in neutral?). The answer to this question may help you to pinpoint the source. I know it's stating the obvious but the fact that you're hearing a grinding sound means it's caused by something that is moving relative to something else. Again this should help narrow down the cause.
it depends if you have 2WD or 4WD, probably either your CV joints, or your wheel bearing, also have your upper and lower ball joints looked at, durangos are bad for those going out. 4WD could have additional problems, like transfer case, front axle bent, and other 4WD probs. i had a similar problem and it was my wheel bearing. buy it offline, not at the parts store, it saved me $140. compared to O'riely Auto Parts.