An expert who has achieved level 3 by getting 1000 points
An expert that got 20 achievements.
An expert that got 10 achievements.
An expert that got 5 achievements.
Re: head light bulb replacement
Open the hood. Look at the top edge of the headlight. About 1/3 to 1/4 of the way in from the inner edge of the housing, you'll see a rectangular clip, and about 10" outboard of that clip, you'll see a matching one. Simply pull up on those clips - they're slide locks for the headlight housing. Once you pull them up, you'll be able to pull the whole headlight housing out towards you, and from there, you can unclip and remove the bulb sockets in question.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
LOOK IN YOUR GLOVE COMPARTMENT FOR THE OWNERS MANUAL. LOOK IN THE BACK INDEX OF MANUAL LOOK UP BULB REPLACEMENT. IT WILL SHOW AND TELL YOU HOW TO REPLACE HEAD LIGHT BULBS. YOU NEED TO WEAR CLEAN LATEX GLOVES WHEN CHANGING HALOGEN BULBS BECAUSE OILS FROM FINGERS AND HANDS WILL CAUSE THE HALOGEN HEADLIGHT BULBS TO OVER HEAT AND BLOW OUT. HALOGEN BULBS ARE EXPENSIVE THEY COST FROM $10.00 - $20.00 BE SURE TO WEAR CLEAN GLOVES WHEN HANDLING THEM.
Last I checked Chrysler had changed it's headlight mounting from external screws to just the two adjusting screws. Looking down from the top, you should be able to see two Torx head screws that are used to adjust the headlight assembly. The remove teh head light assembly you remove those and the assembly should come right out. Both of these screws or adjusters will be 6 to 8 inches long. I hope your not removing this to change the headlight it self. Chrysler has been using the insert bulbs for several generations and to replace the bulb you only have to unlock the collar on the back of the light assembly and pull and then replace the bulb.
You dont actually replace the headlight , just the bulb inside the headlight.. look inside the engine compartment at the back of the bulb , you just unplug the wire and either turn the bulb 1/4 turn to remove , or there will be a little spring clip.
Headlight Bulb Replacement 1. Open the hood and remove the two headlight mounting screws. 2. Remove the push-in fasteners for the grill area by prying under the head of the fasteners with a flat bladed tool.
you change the bulb from inside the engine compartment . raise the hood and feel for a plastic retaining ring in the back of the headlite. Loosen 1/4 turn and bulb socket and old bulb will pull out from the headlite assembly Unplug the old bulb and replace with new one . assemble in reverse order.
In the trunk, in the rear corners, you'll see some plastic "caps" with tabs on them, similar to wing nuts. Remove those, and the taillight comes right off the back of the car. That will allow you to replace the bulbs.