Question about 2002 Mitsubishi Lancer

2 Answers

Where is the Fuel Gas

Mitsubishi Lancer 2002 runs very bad. Turn air cond. on and the car turns off. Car shakes a lot.

Posted by on

  • 2 more comments 
  • naynaty Aug 25, 2008

    I check the codes and gave me that one of the o2 sensors was bad. I have changed the upstream but not able to change de downstream.

    Then my other question is where the fuel filter is because I have got out of gas several times and because of that the filter may be clog.

  • riko200 Dec 19, 2008

    my radiator head burst, changed it, change fan control unit, Not too sure but temperature gauge is half way and a little above sometimes, how can i test my thermostat and fan control unit.

  • yadayada
    yadayada May 11, 2010

    What repairs have you done?, check the engine trouble codes and let me know what they are, check the fuel pressure.

  • Anonymous Mar 20, 2014

    neutral blinks while the car run fast, my car is mitsubishi lancer 2001 a/t



2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Mitsubishi Master
  • 77,202 Answers

The fuel filter is located WITH the fuel pump it is called a fuel module, it is what Mitsubishi calls this bundle, to access remove rear seat cushion under it you will find the a sheet metal access cover, under that cover is the module assy. This will be a new fuel pump and filter you are replacing, so make sure you are doing a repair you need first.

Posted on Aug 25, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

The fuel filter is located under the back seat on the left side. If you attemp to change it by yourself make sure your have an hour or two if you're not used to it. First remove the bottom part of the back seat by pulling with your hand. Put your hand in between the upper and the lower part of the seat and pull it upward and then unsnap the front (2 snaps).

Then remove the rubber insulation and the acces cap using a #2 phillips screwdriver. And then the work begin... Most of all make sure you do not break any bolt (there are 6). $ of them will be quite easy to remove but watch out for the 2 last nuts... It will be rusted.

Removing the bolts will loosen the metal ring that presses the plastic part (the fuel filter) on to the rubber seal and the tank. The filter is also the pump mounting bracket.

Posted on Nov 10, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Fuel gauge does not work correctly on my 2002 mitz. lancer

Sounds like your sensor in the gas tank is starting to go

Jan 31, 2015 | 2002 Mitsubishi Lancer

1 Answer

2002 Mitsubisihi Lancer will turn over but not fire

If the plugs aren't firing then it won't turn over. You must have something else going on. "turns over" to me means it is getting fuel and the plugs are firing. Are you sure it is turning over? If it isn't turning over then the starter is grinding away and nothing is happening or you just hear a clicking noise but when a car is turning over you hear it running, meaning it is firing on all or some cylinders.

Mar 21, 2012 | 2002 Mitsubishi Lancer

1 Answer

What cause my mitsubishi lancer 2002 to burn alot of gas

more then normal,you have air intake before air intake,car is sucking air not to design.chk .if you keep on driving,converter will chk o2 senser #2.

Feb 20, 2012 | 2002 Mitsubishi Lancer

2 Answers

2002 lancer wont start unless throttlebox gets direct gas or starting fluid

test for fuel pressure. It could be fuel delivery related.

Feb 20, 2011 | 2002 Mitsubishi Lancer

5 Answers

I have a mitsubishi lancer cedia model 2000 frequent stall when driving i switch it off and on again in the ignition and come to live again for a few miles and does the same again what could be the cause

If you have the GDI model,they were designed to run on very lean air/fuel ratio.
Once the mileage is up a bit a lot of problems can be traced back to a high carbon build up in the intake manifold.

Apr 24, 2010 | 2002 Mitsubishi Lancer

2 Answers

Car is not idling. Need to keep foot on the gas pedal to start.

Hi there,
there is a screw(situated in a hole) on the throttle body and this can be adjusted to increase the rpm. anticlock to raise the rpm.

Apr 23, 2009 | 2002 Mitsubishi Lancer

1 Answer

2002 mits. lancer shakes and almost dies when stopped.

it could be that your air mass meter is going bad, or that you have a vacuum leak. check your air filter how dirty it is.
if it's too old or dirty replace it because it will kill your air mass meter and will cost you 10 + times more.

Jan 08, 2009 | 2002 Mitsubishi Lancer

2 Answers

The air conditioning in my 2004 mitsubishi lancer will periodically stop blowing cold air.

It could be a number of may be low on freon...the drier/filter may need replaced...could have a bad expansion valve... regardless it should probably go to a qualified shop to be checked out...

Oct 02, 2008 | 2002 Mitsubishi Lancer

Not finding what you are looking for?
2002 Mitsubishi Lancer Logo

337 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts


Level 3 Expert

77201 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8743 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides