Question about 1995 Ford Bronco

1 Answer

Ok super weird

Ok i pluged in the tackometer....well first i unpluged it a couple of days ago cause when it was plugged in the truck would run funky but still run and then when it was unplugged i had my acceleration back so i left it unpluged but i pluged it back in and my starting problem went away any ideas?

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has written 7 tips or uploaded 3 video tips

  • Master
  • 674 Answers

You just nailed it down to the TIF moduel this is a solid state moduel make sure the wires have a good connection inside the dist also. sometimes in the dist the pickup coil rubber will go bad and cause problems if the rubber in the dist pickup where it connects to thr TIF module is weak (needs to be in good solid shape) check this out i think your close.ok super weird - bafac7a.gif

Posted on Aug 25, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What caused the car to lose power and engine light ignited

Go back to the servicing dealer quickly and advise the peoblem started right after they did what they did and ask them to fix it.

Sep 12, 2014 | 2010 Kia Forte Koup

1 Answer

I have a 1997 discovery v8 was running fine until a couple of days ago put new fuel filter on and it helped a little i then changed the spark plugs and it improved a lot i went out today it turned over a...

Hi justin, sounds like you have a headgasket problem are you going through any water? If not you may have a leaking fuel injector or faullty fuel pressure regulator. you either have fuel or water leaking into a cylinder causing it to miss fire on first start up.

Nov 23, 2012 | 1995 Land Rover Discovery

1 Answer

Problem started suddenly two days ago. Engine is 4cylinder - Autozone diagnostic showed codes p0441, p0442, p0446. Replaced spark plug wires and disconnected battery to reset computer. Now - no check...

PO441 ,PO442 codes have to do wit the oxagen sensors, If there is a problem with both of them,Or your cat is pluged up ,The car will not run (Properly)

Nov 11, 2012 | 2004 Hyundai Santa Fe

1 Answer

I bought this car and it seemed to run ok. I had to replace the oil pump seal , so I changed the timming belt. The timing belt seems to be 1/2 tooth off. I have checked it and rechecked it. Also I...

Hi the IISC the TPS can both cause erratic and fast idling, also air leaks, the Volume Air Flow sensor to name a couple of other causes, as the code points to the TPS i would be inclined to trust the code, i would want to get the timing right but that in itself wouldn't cause the problem you are having, poor performance would be,

Mar 16, 2010 | Toyota Camry Cars & Trucks

1 Answer

Engine Flooding

Double check all freeze plugs they have been known to cause funky problems, that also could be the fuel pressure regulator malfuctioning...
hope this was helpful!!

May 19, 2009 | 1998 Chevrolet S-10 Pickup

1 Answer

1991 Toyota Previa starts sometimes but not others

Steve I had similar problem not too long ago about a week to be precise. Your alternator is beginning to go bad. You might service or better still replace it.

Rete this fixya

Mar 22, 2009 | 1991 Toyota Previa

1 Answer

2.0 litre 2002 wont start

hi from uk just a couple of questions ? as car is now with this cold starting?? when engine does start do you get blue/black heavy smoke and engine has a slight hesitant ? then smoke clears ? engine runs ok? and no problems starting for rest of day ? if this sounds like the problem you have? then this is the glow plugs that arenot working at optimum you only need 1 or 2 poor and engine has trouble cold starting may i suggest you first check that when you put ign on there is power reaching the 1st glow plug at least? if ok this will eliminate relay and fused link? these glow plugs must glow white hot from tip upwards you can change these diy with a little patience and are obtainable fro most motor super shops here in uk anyway hope this helps?and inspires you? please update on how you go on? or if you req further info ?

Nov 21, 2008 | 2003 Hyundai Santa Fe

2 Answers

Car won't run after rain or after it sits for a couple days

you need a tune up new plugs wires and cap an rotor

Nov 07, 2008 | 1990 Geo Prizm

Not finding what you are looking for?
1995 Ford Bronco Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

78010 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers


Level 3 Expert

5651 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides