Question about 1996 Ford F150 Regular Cab

1 Answer

Does not start

Motor turns over no spark or fuel

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Guru:

    An expert who has written 7 tips or uploaded 3 video tips

  • Master
  • 674 Answers

The first place to look is on your battery cables . look at the negitive cable at the battery you will see the main cable coming out and also a smaller black wire. this is your ground for the computer. if it has a bad connection it will not start. this is the most common problem to start with let me know how you do.

Posted on Aug 24, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2004 Sierra 1500 turns over but doesn't start


Fuel pump or spark see if you have spark... pull a spark plug wire put a bolt in there set it near the motor, crank it see if you see or hear spark... If you have Spark turn to the fuel system...

Feb 02, 2018 | Cars & Trucks

1 Answer

I have nisssan frontier o6 4 cylinder, I put a fuel pump , crank sensor, spark plug, still no start, engine spin over.


I would first check fuses. Second, check for any codes in the system. To make a motor run you need air, fuel, and spark. Pull a spark plug and use a spark plug tester while cranking the motor to determine if you have spark. If no spark, and you have replaced crank sensor I would suspect ignition control module unless you have coil over plugs. Also, when you turn the key on, listen for the injectors squirting fuel. Hard to diagnose with such little info. Just know your are missing one or more elements causing it not to start. If there is a mechanical issue inside the motor this could also cause a no start condition.

Mar 16, 2016 | Cars & Trucks

2 Answers

Motor turn's but doe's not start


List everything. Do you have spark and fuel and fuel pressure?

Jan 29, 2016 | 1996 Jeep Cherokee Sport

1 Answer

I have a 2004 geand am. the motor turns over but wont start. I changed the fuel pump, the ignition is good, fuses are all good but it will not start


Check for spark (pull a spark plug and arc it to a grounded surface) and check for fuel to the engine (can be done through the spark plug hole opened by removing the spark plug)

Apr 17, 2014 | 2004 Pontiac Grand Prix

1 Answer

ENG TURNS OVER BUT DON'T START


Need to check for fuel pressure. There is a schrader valve on the fuel rail on the belt side of the motor under the upper intake. Really common for those vehicles' fuel pumps to **** out. If you have fuel check for spark. You can do that by removing a spark plug then connecting the wire back to it and leaving the plug tip near unpainted metal on the motor. Step back DO NOT TOUCH THE PLUG WHILE THE MOTOR IS BEING CRANKED and have someone else try to start the car. You will see a blue or white spark at the tip if you're getting spark. An orange or red spark indicates a weak ignition coil.

Jan 04, 2012 | 1996 Buick Roadmaster

1 Answer

Engine turns over but wont start? it has spark! and fuel!


Pull out # 1 spark plug and put back into plug wire, rest on motor block so that end of electrode is against metal. turn motor over and have a finger or compression gauge in # 1 cylinder, check to see if spark occur at same time as compression (compression will blow air past finger or raise gauge). When you say it has fuel do you mean gas tank has fuel? Are you sure fuel is getting to the cylinders? are plugs wet with fuel? Does it turn over but kinda thumps or backfire (Caugh)? Check the spark and compression first. if they don't happen at same time, the timing skipped or belt broke. if all is good pull plugs and inspect, could be flooded (WET) from fuel. either replace or spray with starting fluid and compressed air to dry them. spray starting fluid into air intake if starts then stalls, try again, if same thing happens then you have a fuel problem. try these suggestions first 1/2 hr time table, hopefully sucess, if not it sure indicates fuel.

Jan 10, 2011 | 1995 Subaru Legacy

2 Answers

Where is the fuel pump on a 1973 winnebago dodge 318? It will turn over, but will not start. Do you think its the fuel pump or something else? It has not been started for several years. Thank you so much...


Try putting a little gas in the top of the carb. Then try to start, if it starts then it's a fuel problem, clogged filter, lines, carb or fuel pump. If it doen't start with the gas then check for spark, disconnect a spark plug wire put on a spare spark plug, ground plug threads to motor and have someone turn over motor. You should see a spark between plug and electrode. Also you could check compression of engine, rings could be siezed and no compression will mean no start. If low or no compression, pour wd-40 or other lubricant into spark plug holes and let sit for a couple of days. Hopefully that would unsieze rings.

Oct 20, 2010 | 1983 Dodge Pickup

2 Answers

Wont start.


If it will turn over check to see if its fuel or fire. To check for fuel, spray quick start for a few seconds into intake. If it starts and stops. its fuel. Change fuel filter and check fuel pump. If it does not start its fire, Could be distributor cap, rotor, coil, spark plug wires or spark plugs. If it does not turn over it could be battery or starter. Check battrey connections, ground strap from motor to body and ground wire from battery to motor and body.

Jul 26, 2010 | 1995 Honda Civic

1 Answer

My 1996 crown vic will not start motos turns over and trys to start but wont I have replaced intake manifold spark pulgs. motor has spark


basics,,,air,,fuel,,spark,,compression,,timing,,,pull a few plugs,,smell them for fuel,,if dry,,,take snorkel off throttle body,, open throttle body or flap half way,,spay a little starting fluid or injector spay into throttle put the snorkel back on see if motor fires up,,if so then ck fuel delivery & pressure,,,,hope it helped

May 28, 2010 | 1996 Ford Crown Victoria

Not finding what you are looking for?
1996 Ford F150 Regular Cab Logo

Related Topics:

42 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

fordexpert

Level 3 Expert

5610 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...