Question about 1995 Saab 900

1 Answer

Saab 9-5 SE 2000 year

The revs are very slow at reducing between gear changes and I have noticed the throttle cable at the engine side is rather losse. How can I tighten this? Thanks,

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 421 Answers

There is a recall on some of the throttle body butteryfly doors sticking try this -jeff

Posted on Sep 02, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Revs high when i change gear


Is it possible the clutch pedal is interfering with the throttle? Start the engine in neutral and allow it to idle. Press only the clutch pedal down and see if this increase the engine speed. If it does speed up the engine and slows back down when you release the clutch then somehow this operation is where your fault lies. If it doesn't alter the idle speed, then rev your engine and release the throttle to see if it returns to idle immediately. If it is slow to return to idle then your throttle cable could be sticking. This means when you change gear lifting off the throttle has little effect and depressing the clutch to change gear causes the engine to race as the throttle is still partially open.

Aug 23, 2014 | 2005 Ford Fiesta 1.3

1 Answer

Saab 1.8 diesel 2007 the problem iam


the car will maintain 850/900 revs in all gears on the flat and only decelerate when the engine is reving over 1500.its called auto idling valve.....(computer controlled..)

Apr 12, 2010 | 2008 Saab 9-3

1 Answer

2001 Saab 9-5 SE It will be running great and


Change crankshaft position sensor,located on a back side of the engine block next to the gearbox on a front side.

Apr 05, 2010 | 2008 Saab 9-5

1 Answer

Saab 9-5 need to give alittle throttle for cold engine start


the idle air control valve may be bad or just needs cleaned out. idle air control valve acts the same as a choke. if it is messing up it will cause engine not to run right.

Jan 27, 2010 | 2008 Saab 9-5

6 Answers

I have a Saab 9-3 2.2 tid which I bought a week ago. The engine management light came on after the first day of driving causing the car to go in to limp mode. The garage replaced the airflow unit and the...


I am not a mechanic but i have got the same model saab which i have had for 5 years. Same issue a couple of years ago, for me it turned out to be a hole in the hose to the intercooler. Loss of power and smoking. Once repaired all ok though

Nov 16, 2009 | 2003 Saab 9-3

1 Answer

2000 saab 93. Slow acceleration out of gears, especially first.


Car picks up speed if you accelerate slowly, but the engine races, with minimal speed increase of the vehicle, when the throttle pedal is pushed harder? I'm not aware of the typical layout of the Saab, so while these things below are what I would suggest you look at... Not all will apply. Note that if the clutch plate is worn or otherwise slipping, the more you race the engine, the sooner will you burn off any remaining clutch life. Take things easy 'till you have a solution..... On any vehicle, this is a classic sign of a worn, damaged, or out of adjustment clutch. Or Possibly oil contamination from a leaking crankshaft rear oil seal. It causes a glaze on the linings of the driven plate and loses friction. Or The clutch pedal is not returning to it's normal rest position when released. Check for objects trapped between the pedal and the vehicle surfaces. Or The cable (if used)may be binding, thus the clutch doesn't fully return. It may be out of adjustment. Check for adjusting points at the cable ends. If no slack exists in the cable, it appears as though the clutch is worn. The clutch may be self adjusting. It's possible for self adjusters to seize. Or The hydraulic system (if used),has sticking cylinders. You may be able to clean and reuse the cylinders....

Jun 14, 2009 | Saab 9 3 Cars & Trucks

1 Answer

2000 Saab 9-5 SE 3.0 V6 it needs new driver side mirror


Rockauto.com partstrain .com... the best prices and and you get almost everything ..../ Car-parts .com junk yards parts

Feb 26, 2009 | 1999 Saab 9-5

2 Answers

Bucking in every gear at 2000 revs. saab 93 1999.


maybe **** in fuel ,tank ,line,ect

Dec 11, 2008 | 1999 Saab 9-5

1 Answer

Bucking when revs hit 2000 in every gear?


Hi the car may have been run low on fuel and sucked some of the dirt that builds up in the fuel tank to the fuel filter starving the car of fuel when its looking for more

Solution.... change the fuel filter and we can go from there

Hope this helps

Regards
Steve

Dec 11, 2008 | 1999 Saab 9-5

1 Answer

Rev high when changing gear up


my friend has same model its normal he said it does it more so when its cold

May 24, 2008 | 2003 Honda CR-V

Not finding what you are looking for?
1995 Saab 900 Logo

Related Topics:

150 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saab Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

yadayada
yadayada

Level 3 Expert

61249 Answers

rgbypoet

Level 2 Expert

161 Answers

Are you a Saab Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...