Question about 1999 Toyota Camry

2 Answers

99 Camry it keeps blowing 10amp fuse

Hi, I have a 99 Camry and it keeps blowing the 10 Amps fuse marked as "guage" in the fuse panel behind change drawer below left side of steering wheel.
but sometimes it works fine with no problem, i have tried everything I know. also, have taken it to a mechanic, he drove it for almost a week with zero lost of fuse. as a result my mechanic can't tell what the problem is.

Posted by on

  • soveryimp Dec 06, 2008

    Well when my fuse blows the transmission wont work as well as it not starting sometimes I have taped off all the wires where there once was a radio and still my problem persists what should i do??

  • Jim  K
    Jim K May 11, 2010

    Is the radio in the car the factory radio that comes with the car?

×

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 91 Answers

I didn't mean it was possibly the aftermarket radio it self. I was thinking that who ever installed it may not have capped off the dimmer wire on the radio harness and it's shorting out once in awhile. People that don't know what their doing figure that sience the radio works the other wires left over don't do anything and leave them hanging.
That's why I asked for the clarification.
Installing radio's for so long you come across just about everything. If you bought the car used and it has the factory radio in it you don't know that the previous owner didn't take out his alpine and cobbed the factory radio back in etc.

Posted on Sep 15, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Toyota Master
  • 1,861 Answers

I agree with lobsterman...Aftermarket radios kill the gauge fuses.

Posted on Sep 08, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuse for the brain on a 99 chevy malibu


there are three fuse's for the ( pcm ) powertrain control module ! engine brain ! two are in the under hood fuse/relay junction block.
it is marked pcm / batt. fuse.10 amp. the other is pcm / ign fuse 10 amp. and then there is one in the let hand instrument panel fuse box. open the driver door at the end of the dash pull off end panel, fuse box behind there. fuse is marked pcm / acc 10amp .

now what is the problem your having ? i can help !

Jan 21, 2015 | 1999 Chevrolet Malibu

1 Answer

What is the fuse number for driver cluster, temp, fuel, sensors, and radio on 2002 Pontiac Montanna


Do you know where the Instrument panel fuse block is ? Open the right front door, end of the I/P or dash. End panel comes off . just grab an pull. Fuses under panel and are marked on inside of panel. There are four fuses. Cluster /Batt 10 amp fuse , PCM/PASSKEY/ CLUSTER 10amp , IGN1 10amp , and MALL/CLUSTER 10amp fuse .

Jan 11, 2015 | 2002 Pontiac Montana

1 Answer

Is it ok to put a 15 amp fuse on a 10 amp starter fuse for a 2004 grand am


You should never increase the size of the fuse in anything because you can potentially cause a fire. Are you sure the original fuse was 10 amps? It sounds like if it is for a starter the fuse size should be substantially larger. Check the fuse panel just to make sure that the original was only 10 amps

Dec 16, 2014 | 2004 Pontiac Grand Am

1 Answer

10amp meter fuse keeps blowing


SOUNDS LIKE THE MLPS ON THE SIDE FOR THE TRANS IS BAD

May 11, 2014 | 1995 Nissan Maxima

1 Answer

What would it do to my navsure n420i car sat nav / radio if i put a 13 amp fuse in if it's a 10 amp radio


The fuse is made to protect a 10amp draw 13 amps will start burning wires you need to follow the specs if your 10amp is blowing then there is a circuit prob.

Jan 18, 2012 | Cars & Trucks

1 Answer

99 camry fuse


1 for the fuse marked guage check the wiring harness in the trunk left side arm for
broken wires 2 check the black\ red wire from the neutral safety switch

Jan 11, 2012 | 1999 Toyota Camry

1 Answer

Keeps blowing starter fuse when you turn the key to start engine.


YOU GOT A IGNITION WIRE TO STARTER SHORTING TO GROUND.

May 06, 2010 | 2000 Toyota Camry Solara

4 Answers

99 camry gauge fuse blowing


maybe its the board holding the fuses faulty

Feb 25, 2010 | 1999 Toyota Camry Solara

Not finding what you are looking for?
1999 Toyota Camry Logo

481 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

63801 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...