Question about 1998 Isuzu Amigo

Open Question

1998 isuzu amigo stalls while idling

Symptoms include: stalls while idling but easily restarts, has a tough time accelerating, and check engine light has been on prior to these problems starting.

Posted by on

  • lsadz Dec 22, 2008

    I am not sure if it is exactly the same, however for what it's worth... my amigo was stalling out while driving usually when I am going 65 and have to slow down to 25 in about a mile entering a town where I live. I can easily restart while car is rolling. This happen at the same spot for a few days and I finally got it checked, they said it was my air sensor, and it would cost me about $200 to fix, and yes my check engine light kicked on and would stay on even after the car was going. They gave me the paperwork of the dignostic test and I looked up the numbers on the computer and that's what it was indeed. Hope it helps.

×

5 Suggested Answers

  • 8 Answers

SOURCE: thermostat on 1998 Isuzu Amigo

Yes, It's under the intake manifold. The manifold would need to be removed Lower hose from radiator is attached to steel pipe leading to it. It will not be an easy mission,and the new thermostat is rated for I believe 170 degrees. That's not much help to keep the interior warm with a rag top when it's 20 below zero.

You can boost the heating level by adding vinyl cover over the front portion of grill. Any boat interior shop has the material. Modify any large air leaks. Use the fan to keep fresh air filling vehicle, not recirculate.

Posted on Nov 16, 2008

  • 1 Answer

SOURCE: 1998 amigo timing 2.2 liter

The timing marks on the cam shaft sprockets are easily to see when you get the timing cover off. When the two cam shafts are lined up (pretty much at the top), then the crank should be almost down at the bottom.
Get yourself a good shop repair manual - I got mine from E-Bay for less than $15.00 (used).
Also, if your going to change the timing belt, have the water pump replaces at the same time.

Posted on Dec 28, 2008

emissionwiz
  • 64034 Answers

SOURCE: where is the water pump located on a 1993 isuzu amigo

it is on the front of the engine, the cooling fan is attached to it, do u have the new part?

Posted on May 30, 2009

  • 1 Answer

SOURCE: looking to buy a 1998 isuzu trooper but the check engine light is on. should i buy anyway

Remove cover from the relay and fuse box under the hood. Find the fuse for the ECM and remove. Wait 20mins and replace. If the light comes on again see a mechanic. I've had this problem over about 10 years and it is only a false alarm. If the problem persists see a mechanic. DO NOT TRY TO USE ANY CAR BATTERY POWERED DEVICE IN THE CAR UNTIL THE FUSE IS REPLACED

Posted on Jun 15, 2009

  • 52 Answers

SOURCE: Adding freon to 98 Isuzu Amigo

You need to add the freon on the low side which is usually indicated by a blue cap. The red cap is the high side port. Never add freon using the high side port. Typically if you are buying a guage set from your local auto parts store, it will only attach to the low side service port because they are diffent types of connections. Another easy way to tell is to turn your AC on and feel the lines that the ports are attached to. The low side should be cold/cool and the high side will be hot.

Posted on Jun 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Isuzu amigo with oil light on when idling


Hi there
could mean 1 of 2 things oil sender unit is faulty or oil pressure is low, you will need to have it checked by a mechanic

Aug 27, 2014 | 1998 Isuzu Amigo

1 Answer

What would make a Isuzu amigo to suck to much air, and idle high?


You need to check the coil packs, O2 or to lower the idle by loosening nut on back of jets and adjusting screw until idle is set as low as you want it but I would suggest 5-7 MPH. Tighten nut to lock in screw. This is a mechanic's cheater adjustment that takes less then 2 minutes to do.

May 22, 2014 | 1998 Isuzu Amigo

1 Answer

Oil light flickers on and off, and is also leaking below.


Oil pump is attached to the bottom of the engine. you have to remove the oil pan to get to it. Chgeck your filter first before assuming the oil pump is baf. A clogged filter can cause the same light to go on.

Mar 21, 2014 | 1998 Isuzu Amigo

1 Answer

99 amigo Timing???????


you should not change the belt maybe now its not in the same position and that's a big problem

Mar 13, 2012 | 1998 Isuzu Amigo

2 Answers

1998 isuzu amigo 2.2l 5 spd 4 cyl .\r\ni need to


in all fuel injected cars you do not adjust idle. All you can do is clean the throttle and replace the Idle Air Control valve and check data thru a scanner to see if any sensors are out of specs. If this car has a maf sensor in the air filter tube it could become contaminated and cleaning or replacemnet will allow it to see more air which in turn allows the computer to add more fuel for better idling and accelration.

Jun 11, 2010 | 1998 Isuzu Amigo

1 Answer

Idle problems, when stopping car stalls, sonetimes


mcdvito75 Here, Sounds like an idle speed motor or the idle speed sensor. Have your local shop check it out.

Jan 04, 2010 | 2001 Isuzu Rodeo

1 Answer

Code P1441 check engine light


Always check in at Planetisuzoo.com Hundreds of pros always ready.

Jun 26, 2008 | 1998 Isuzu Amigo

Not finding what you are looking for?
1998 Isuzu Amigo Logo

Related Topics:

64 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

64034 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...