An expert who has achieved level 3 by getting 1000 points
An expert that got 10 achievements.
An expert that got 5 achievements.
An expert whose answer got voted for 100 times.
Re: trouble codes for 1993 Dodge Daytona with 3.0 liter
Trouble Code 12 is a special case code that is not logged into the ECM's Non-Volatile Memory (NVM) when detected. When the ignition is "ON" and the ECM detects no ignition reference pulses coming from the ignition module, it illuminates the Service Engine Soon lamp. CODE 22
Trouble Code 22 indicates that the Throttle Position Sensor (TPS) is reading abnormally low. TPS volts should be close to 0.42 V at closed throttle and rise smoothly in about 0.02 volt increments to a maximum reading of about 4.85 volts at WOT CODE 35
Trouble Code 35 is not used in the Turbo cars. If this code appears while a computer is connected to the ALDL connector, it is probably the result of a bad cable connection at the PC or the ALDL connector. Reseat the cable connections.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
www.allpar.com/fix/codes/faults/code-41.html Possible reasons for Chrysler fault code 41: Alternator field control circuit open or shorted. ... allpar, the Chrysler - Dodge - Plymouth - Jeep site. Note: Allpar ... FauxPar: Return of the Barracuda, 1987-1996 Dodge Dakota pickup trucks, Pinner: ...
hello i got a 1990 dodge daytona shelby the code 13 is MAP sensor signal to the computer (ECU) not changing so the map sensor is should be on the firewall with a vacuum line on it little black box looking thing well make sure it plug in and good and that it dose not have a leaking vacuum line if that dose not work you have a bad map sensor thay run about 30 to 100 at auto zone o onec you think you fix it remove the battery term for about 5 mins with the key on and trun the key off before conttecting the battey back up drive for about 20 mins to see if the code show up if you get code 55 all that means is end of falt code list you mite get a code 12 meaning The battery has been disconnected and the computer (ECU) has been reset hope that help keep that daytona runing it a good car
hello i got a 1990 dodge daytona shelby the falt code 34 is 1987 and later models: cruise control servo failure well for your radio there is lose wirng harness make sure there all plug in all the way on the back of your radio you may have a lose fuse in the fuse box