Question about 2007 Ferrari F430 Spider

1 Answer

Radio passkey request

My f430 is asking for a key when i turn on my radio and its now says wait 2700 secs with a padlock sign next to it

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Guru:

    An expert who has written 7 tips or uploaded 3 video tips

  • Master
  • 674 Answers

If the pass lock isnt in your owners manual you will have to go to the dealer and have him override threw his handset. no other way i have found yet.

Posted on Aug 24, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I NEED A KEY CODE FOR THE BUILT IN RADIO IN A FORD FIGO 1.4 AMBIENTE 2012 MODEL


Try this, found it on another answer board.

Press and hold the Auto button. While holding the Auto button, push and hold the Track Up button. The “_ _ _ _” will disappear after about 5 sec. Enter KCAR using the remote control from a higher end CD Receiver or any Excelon CD Receiver. Enter "KCAR” with the remote controller as described below. “K”: Press TRACK UP key (>>|) after pressing 5 key twice. “C”: Press TRACK UP key (>>|) after pressing 2 key once. “A”: Press TRACK UP key (>>|) after pressing 2 key three times. “R”: Press TRACK UP key (>>|) after pressing 7 key twice. * If you commit a mistake in the code entry, the unit enters the code request mode again. Press the Track Advance button on the remote to enter the override code. The unit will enter the All Off or Standby mode if done properly. Video Unlock: Use a remote from a higher end CD Receiver or any Excelon CD Receiver. Some Video remotes will work, switch on remote must be set to AUD. Press 55222277 on the remote. There will be NO visual verification when entering the override code. Head units with a Up / Down Volume control buttons: Press and hold the Volume Up button. While holding the Volume Up button, push and hold the Disp button. The “_ _ _ _” will disappear after about 5 sec. Enter KCAR using the remote control from a higher end CD Receiver or any Excelon CD Receiver. Enter "KCAR” with the remote controller as described below. “K”: Press TRACK UP key (>>|) after pressing 5 key twice. “C”: Press TRACK UP key (>>|) after pressing 2 key once. “A”: Press TRACK UP key (>>|) after pressing 2 key three times. “R”: Press TRACK UP key (>>|) after pressing 7 key twice. * If you commit a mistake in the code entry, the unit enters the code request mode again. Press the Track Advance button on the remote to enter the override code. The unit will enter the All Off or Standby mode if done properly.

Read more: How can I get the key code for ford figo radio systems? - Radio system key code ford figo :: Ask Me Fast at http://www.askmefast.com/How_can_I_get_the_key_code_for_ford_figo_radio_systems-qna4609185.html#q2909005

Dec 09, 2015 | Ford Cars & Trucks

1 Answer

My 2004 Chevy suburban won't start but there is a locked padlock on dashboard , is this why?


sound like problem in the theft security systm,try this insert another key in the ignition switch, the other key could be worn where pcm and bcm dont recognize it. and switch ignition on engine off watch padlock symbol with ignition switch left on 10 minutes the padlock symbol will extinguish or turn off then you will turn off ignition switch wait 5 seconds then try starting vechicle if start your theft security failing need let dealership check it out.

Aug 27, 2012 | 2004 Chevrolet Suburban

1 Answer

05 Mailbu shuts down after 3-5 seconds after starting


it is a problem with the anti theft system
to reset it to the key
you put the key in turn the car on do not start the car
the securty light will flash wait untial it stays on (it takes about 1 min.) turn the key back to off you have to do this 3 times. you only have 10 sec. to turn the key to off after the light stops flashing.
This will program the passkey 3 system to the key you are trying to use

Feb 14, 2010 | 2005 Chevrolet Malibu

1 Answer

Programming 2nd key, 2007 escalade


The correct procedure is to put in the original key to the On posistion.
Remove and insert the second within 10 seconds. Turn to the On. Wait like 7 seconds. Then remove the key, reinsert to test.
The key (no pun intended) here is to wait for the security light to go out.

Put in your original key or the one the car already knows. Wait for the light to go out (the little car with the padlock) and then turn the key off, swap in the key you wish to program, then wait again for the security light to go out. You are done.

Oct 18, 2009 | 2007 Cadillac Escalade Ext

1 Answer

CAR ASKING FOR IMOBOLISER CODE, HOW DO I INSTALL


Press reset button located to right of led for 2 seconds led will flash
Release button
After 2 secs led will flash once
Enter first digit by pressing reset button relevent number of times
After 2secs led will flash once
Enter next digit by pressing reset button relevent number of times
Repeat operation for remaining digits
if code is entered correctly led will flash
if code is entered wrong led will remain lit but not flash
Note if one of the digits of the code is a zero
after the single flash DO NOT press button but wait for next request and enter the next digit.

Oct 05, 2009 | 2000 Alfa Romeo 145

1 Answer

My radio display and clock went out on my 2005 Grand Am


Do you have a CD sitting in the radio? If so, find the radio fuse and pull it out for 20 secs and turn the car to the on position and wait 20 secs. Turn the car off again and put the fuse back in. Wait 10 secs and turn the car back to the on position and hopefully the radio will power back on.... some Radios get really picky if a CD has been sitting inside for too long...it worked with a Volkswagen so I don't know if it'll work with a GM... worth a shot

Aug 11, 2009 | 2005 Pontiac Grand Am

1 Answer

Vehicle will turn it on for 5 seconds and die...padlock sign!


best to go to main dealer ask them for advice

Jun 05, 2009 | 2006 Hummer H3

1 Answer

06 hummer displays a padlock and will not start with key


Your security system has locked u out, do a pass key reset, if this does not work then u will need the dealer to test the system for a failed part.

PASSKEY LOCKOUT RESET GM (yes it is GM) CARS 1999 UP
1) Put the key in the ignition and turn to the "ON" position. Leave it that way for 10 minutes. After 10 minutes turn the key and take it out. Repeat this process (2) more times (3 times, 30 minutes total) This should reset the passlock system to recognize your key.

Apr 17, 2009 | 2006 Hummer H3

Not finding what you are looking for?
2007 Ferrari F430 Spider Logo

Related Topics:

276 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ferrari Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

yadayada
yadayada

Level 3 Expert

60960 Answers

brocstar

Level 1 Expert

15 Answers

Are you a Ferrari Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...