Question about 1993 Jeep Grand Cherokee

1 Answer

Grand cherokee/93 power loss to all interior gages /radio ect. engine runs power is auto. restored in 5-10 sec what is causing this?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 74 Answers

Door ajar switch in doors dims lights till off turns radio off clean latches with pbblaster close doors severral times fixed

Posted on Aug 26, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Fuse for radio 1993 jeep Cherokee


anthony he ask for radio fuse.... fuel dont run radios.
the fuse is marked RAD.
did you check all boxes?
fuse boxes ?
the operators guide lists it.
the full book is here
read page 200 pdf
http://www.morris4x4center.com/knowledge-base/index.htm?utm_source=cj#service

read that yet?
under RAD and wiring?
XJ jeep. 93 is first good year.

radio dead or just back lamps in it dead. why must i guess?????
ill pretend the RAD is dead. totally.

fuse 2 is RAD 15amps.
in the book, 1min to find. it.

4.0L engines???? guess that?
pdf page 200 and 142 (4LITER)
radios have 3 power feeds
illum
radio power
memory
ill guess, rad power is dead. runs Cig lighter too... it dead?
ITS MARKED .


24760338-wf3tghvxj2pr5mdmhfccmxag-4-0.jpg

Jul 04, 2014 | 1993 Jeep Grand Cherokee

1 Answer

Non working gages, windows, radio, & loss of power


Good chance that your alternator has gone bad and your electrical system was running off the battery. Best to have a shop re-charge the battery and do a charging test before doing any other diagnostics.

Dec 29, 2012 | 2000 Jeep Grand Cherokee

1 Answer

I have a 93 Jeep Grand Cherokee Laredo and the interior lights are not working along with the radio (factory install) and the power mirrors aswell...what could be the issue?


Most likely sense it was installed by factory, and all these issues came up at once, they probably did the fast easy way, meaning they most likely have them all on same circuit. Some wire short, most likely my guess is the power mirrors, is where I would start with looking for issue. However, what should take car of this first is look in fuse panel, you SHOULD have separate fuse for power mirrors and radio, as well as dome lights, but it is possible, they put them all on same fuse. Thanks Mike from Fixya

mc1bean_54.jpg

Jul 07, 2011 | 1993 Jeep Grand Cherokee

1 Answer

The original motor in my 93 grand cherokee 5.2L seized in June. I bought a good junk yard 5.2L motor from a 98 Grand Cherokee and swapped over the 93 intake and all related electronics. The engine is back...


are you sure those intakes are inter changeable?
if you still have the 98 intake and your 93 block ,sit there and look for any differences in holes or hole locations.
another way to check is when it is running remove the oil fill cap and see if it stalls or picks up speed.

Nov 21, 2009 | 1993 Jeep Grand Cherokee

3 Answers

1998 jeep grand cherokee will not start


Try resetting the asd "auto shut down fuse had a similar problem the jeep would crank but did not get spark or gas also check your fuel pump? and the asd relay may be bad it will prevent the jeep from getting no spark and will not fire some jeeps have security problems

Jun 25, 2009 | 1998 Jeep Grand Cherokee

2 Answers

2001 jeep grand cherokee 4.0 engine shuts off


it is possable/likely a bad ECTS (engine coolant tep. sensor), this can cause the injectors to allow to much fuel into cylinders and cause a low compression and or flooding situation, good luck, marty

Jun 07, 2009 | 2000 Ford Focus

1 Answer

Jeep Grand Cherokee Power Loss


a bad cam sensor will cause vehicle to shut off while driving, and cause a hard time starting. but this usually sets a trouble code p0340. scan vehicle to see if any codes come up. after it is fixed, erase codes with a obd2 scanner. if you do not have one, you can go to any auto parts store and they will erase codes for free.

May 02, 2009 | 2001 Jeep Grand Cherokee

1 Answer

Engine and auto tran removal on a 93-96 grand cherokee 4.0


pretty simple if its the 4.0l start with the radiator next the fan go under the truck disconect exsaust at manifold dis connect trans case if you have a 4 wheel drive this takes alot of weight and length of the trans disconnect all wires and lines to trans since your under there both drive shafts go to top disconnect all wires lines fuel lines ect. next break the motor mounts u wont be able to take these out til u get your cherry picker conected up and get pressure of the bolts. pull motor mount bolts and raise the engine a little. gounder the truck again u might want a jack under the trans drop cross member start pulling

Feb 18, 2009 | 1993 Jeep Grand Cherokee

2 Answers

Running rich. No power. 5.2 v8


it can cause it to run rich because the oxygen sensor may be getting a false reading as to how much oxygen is there....this in turn causes the pcm to add more fuel

Dec 02, 2008 | 1993 Jeep Grand Cherokee

Not finding what you are looking for?
1993 Jeep Grand Cherokee Logo

Related Topics:

144 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...