Question about Jeep Grand Cherokee
It would be nice to know a little more info like it will go up and down or it went back but not foward. it could be a bad wire(broken) could be a bad switch . just need to get in there with a test light and see where your loosing the power. if you have power to the motor and it wont go foward or back it might be the motor. tech scale rating 4
Posted on Aug 23, 2008
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
I just had the same problem. When the seat is powered all the forward, one of the worm drives reached the end of its travel and jammed against the threaded block that it passes through. To fix this the seat has to be unbolted and tipped back. There are four tiny 6mm bolts that hold the motor plate in. Remove these and the motor will come out. The worm drive is bolted in at one end and has a set pin at the other. Remove the worm drive and use a couple of vice grips or equivalent to loosen the threaded block from the worm drive.
Posted on Jun 21, 2009
check fuse.if fuse is good check for power at seat motor.if yes replace seat motor.if no check wires at switch.if wires is not loose or broken seat motor switch could be bad.
Posted on Dec 13, 2009
needs a forward/rearward motor. it has two separate motors under the seat. very common and i replace them all the time. good luck
Posted on Mar 26, 2010
Most common problem is corrosion inside electrical connector to the motor. Either replace or clean out connector. Disconnect battery before doing any cleaning of connrctors. If connectors are a-ok then use voltmeter and see if B+ is making it to seat motor.
If it is then motor is defective . if its not then remove position switch from connectors , use a jumper wire
and jump connectors and see if switch operates motor. If it operates motor then the switch is defective
Posted on Apr 26, 2010
Tips for a great answer:
Sep 24, 2012 | 2004 Chevrolet Tahoe
Sep 12, 2012 | 2009 Chevrolet Impala
Nov 14, 2011 | 2000 Subaru Outback
Nov 10, 2011 | 2005 Kia Optima
Jun 06, 2011 | 1993 Mercury Topaz
Jun 02, 2009 | 2004 GMC Envoy
Apr 19, 2018 | Jeep Cars & Trucks
Apr 18, 2018 | Jeep Cars & Trucks
645 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: