Question about 1995 Jeep Cherokee

1 Answer

Idle start Hello All. canyou people mabye help me out ehre I am in Malaysia and my Jeep Cherokee 1995 does start but I will have to push the throttle to get it started. this problem just happened few days ago. i have no Manual or owners manual, I suspect solenoid on the inlet manifold after the Airivalv inlet. But I cna not adjust the inlet. it remains in fixed position. Brg Stefan V.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 623 Answers

Dirt and crud builds up in the air intake around the throttle plate. It does not take much to choke out the engine either. (so you have to give it more gas) Take off your air cleaner housing and clean inside the air intake throat with some carb clener and a toothbrush.

Posted on Sep 16, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1998 jeep grand Cherokee 4.0 engine has a idle problem. when I start the jeep it runs wide open with no control at the throttle. I Replaced the head on the vehicle.I have checked all vacuum hoses f


you need to check all sensor connections as the crank shaft sensor also will mess up your idle....try slightly unscrewing the tps and push it up or down slightly to see if this fixes the problem.

Nov 11, 2014 | 1998 Jeep Grand Cherokee

1 Answer

1996 Jeep Grand Cheerokee. Will only start will accelerator pushed and will only keep running if it is pushed. If I let off, it stalls completely.


Could be the idle air control valve or a dirty throttle body.
The computer controls idle speed by how much air enters the throttle body and intake.
You would need to check the throttle body and test the control valve.

Feb 15, 2013 | 1996 Jeep Grand Cherokee

1 Answer

Where is idle air control located on 1995 jeep grand cherokee and how to remove and clen..... or just go to goodyear autoservice


You will find an oval shaped connector going into your throttle box. Simply disconnect wire, remove two torx screws and spray with carb cleaner... 15 minutes at most.... Good Luck

Oct 26, 2011 | 1995 Jeep Grand Cherokee

1 Answer

I dont know were my starter ison my jeep grand cherokee limited 1995 canyou tell me where it is and how to take it out and repair it. thank you


Should be on the passenger side at the back of the engine, going into the bellhousing. Should be 2 bolts holding it on and a couple electrical connections. A rebuilt starter will be about $50 if you bring in your old as a core.

Jun 22, 2011 | 1995 Jeep Grand Cherokee

2 Answers

Hello where is the crankshaft position sensor on a 1995 jeep grand cherokee? My jeep would stall out but start right up now it wont start at all even though its trying to. i replace the ignition coil...


on the drivers side if you look straight down in between the intake and the firewall you will see it bolted to the transmission. The harness plug in is in that same area as well.

Dec 07, 2010 | 1995 Jeep Grand Cherokee

2 Answers

96 jeep grand cherokee starts but wont idle


CHECK FUEL REGULATOR ON FUEL INJECTOR RAIL,&ALSO FUEL PUMP, CHARLIE

Feb 21, 2010 | 1996 Jeep Grand Cherokee

1 Answer

95 grand Cherokee 5.2 engine light on flashing code 34


Sounds like your idle air control valve is going bad.  It is located on your throttle body and is held in with two screws.  Let me know if you have any other questions.  Thanks for rating my response and for using FixYa!

May 26, 2009 | 1995 Jeep Grand Cherokee

1 Answer

1995 Jeep Cherokee will not stay running


Did the engine run before the cap,rotor?
The butterfly is operated bya cable from the gas pedal which controls the amount of air into the intake,the fuel is controled by the throttle position sensor,and map sensor and idle is controlled by a idle air control valve which regulated idle rpm by the amount of air allowed into the intake.
I would have to say that either the iac has gone out,or the hole where the iac pintle goes has carboned up blocking air flow,or the worst case the ecm is not the right one from a 1995 to a 1987 motor but if it ran ok before I would look into the probability that your problem is the iac.

Mar 11, 2009 | 1995 Jeep Cherokee

Not finding what you are looking for?
1995 Jeep Cherokee Logo

Related Topics:

108 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...