Question about 2000 Honda Odyssey

1 Answer

Location of connector for OBD tester

How do I locate the connector for the OBD Tester on a 2000 Hoinda Odyssey?

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 16 Answers

Inside van, in driver's seat area, to the right of the steering column, under the dash. It is to the far right under the dash, next to the center section that goes down.

Posted on Dec 28, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

When I hook the tester up to my Ford Taurus, all I get is an err code. help!

What kind of tester ? What year ford taurus ? An where are you hooking up this test ? OBD connector under the dash ?

Feb 27, 2017 | Ford Taurus Cars & Trucks

1 Answer

Why wont obd communicate with diagnostic reader on 2000 dodge ram 1500 5.9

You have a bus communication problem. Start by checking all fuses. Next check all connectors. Specifically the pcm connectors and ground. These are located in the engine compartment on the passenger side behind air intake. I have ha 2-3 of these trucks need either a pcm or connector for open asd relay circuit issues.

Feb 09, 2015 | Dodge Cars & Trucks

1 Answer

Diagnostic port on 2006 f250 5.4 gas location

should be under dash on driverside

Feb 21, 2013 | Cars & Trucks

1 Answer

Obd tester code reader

Should be located under the drivers side dash,under steering column area.

Aug 31, 2012 | 2003 Mazda Tribute

1 Answer

My OBD port is not working on my mountaineer and i went to change the fuse for it and there is no fuse on that Location on the fuse panel..just wondering if this is normal. 2000 mercury mountanieer with...

sometimes you have to wigle the OBD 2 connector on the tester. Sometimes, you have a tool that does not communicate with your OBD 2 system. Go to Autozone and have them do a free scan to see if their tester works.

Fuse 17, 25 amp, yellow in dash fuse panel supplies 12v

PIN 16 Orange, lower right I think is 12v all the time.

Jul 27, 2011 | 2000 Mercury Mountaineer

1 Answer

Where is the OBD connector on a 1988 XR7 Cougar

On the 1988 XR7 the Ford diagnostic connector is located under the hood and just ahead of the right front strut tower. It's not the familiar looking OBD-II 16 pin connector but is the Ford style two part connector consisting of one single wire with a female spade type connector and another odd shaped connector with 5 or 6 female spade connectors in it. The typical auto parts store OBD-II reader won't work to read codes on this one, instead you need someone with an older tester to see what is happening and the data available from the system is quite limited also. Hope this helps and good luck!

Jul 28, 2010 | 1997 Mercury Cougar XR7

2 Answers

Searching for obd 2 port


The OBD Diagnostic Link Connector is located in front seating area, passenger side, under dash, above kick panel, mounted rear of glove compartment.

Don't forget to rate this post, Good Luck!!

Apr 27, 2010 | 1997 Ford Thunderbird LX

1 Answer

Cant access cars computer for codes. it denies ob2 tester access.

I have the same problem. I found out that in 95 chevy used the connector for an OBD-2 system and the PCM for an OBD-1. In order to access the computer you need a scanner that fits the OBD-2 connector and reads the OBD-1 PCM. I called around and either you can take it in (if drivable mine is not) to Knechts and they will scan it for free. Auto zone carries the CP9185 accutron scanner for 250 dollars and if it does not work for some reason you can take it back as long as you don't ruine the package. Other companies make scanners that will work but they all cost 250 or more. Good luck.

Apr 16, 2009 | 1995 Chevrolet Cavalier

2 Answers

Where is the obd located on a 2000 Corvette?

most always the obd connection is mounted on the driver's side right about where your knees would be. it is mounted to the dash

Feb 19, 2009 | 2000 Chevrolet Corvette

1 Answer

Engine light on

look behind the coin pocket / ashtray.  It is a 16 pin OBD II connector.

Dec 29, 2008 | 2000 Acura TL

Not finding what you are looking for?
2000 Honda Odyssey Logo

Related Topics:

840 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

78010 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides