Question about 2003 Jeep Liberty

2 Answers

Jeep liberty transmission problem

I have jeep liberty 2003 and it has gear 3and 4 incorrect ratio. the trany does not want to shift th higher gears- any advice what it could be?

Posted by on

  • Anonymous Mar 16, 2014

    jeep grand cherokee shifts good but not in 4 th gear

  • Anonymous Mar 17, 2014

    jeep liberty transmission randomly downshifts when at approximately 50 kph

×

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 77 Answers

IT COULD BE SOLENOID PACK OR THE GOVERNOR AND TRANSDUCER OR LOW FLUID OR THE MOST COMMON REPAIR SPEEDS SENSORS INPUT/OUTPUT. ALL OF THESE CONTROLS THE SHIFTING. START WITH THE SENSORS FIRST, VERY COMMON.

Posted on Jan 02, 2009

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

If there are no solenoid or speed sensor ( open or shorted) Codes, most likely the overdrive clutch hub is broken or the splines are stripped. O.D. clutch is on for 3rd and 4th gear.

Posted on Dec 16, 2009

  • albertolinar Mar 25, 2011

    I have a 03 liberty it when going into o.d. the rpms jump before engaging feels hard also is the o.d. clutch hud or splines something that it can be done without a complete rebuilt.

×

1 Suggested Answer

  • 117 Answers

SOURCE: I have jeep liberty 2003 and it has gear 3and 4

faulty input speed sensor possible. sensors are fairly cheap and easy to install. no gaurentees because normally u will have more codes then just the 3-4 ratio with a faulty sensor but u may get lucky

Posted on Nov 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Ihave code p0731 stuck in 1st ratio .. what mean that code?


obviously refers to auto trans , could just need the trans fluid level topping up or even changing , if this does'nt resolve the problem then a more in depth diagnosis would be required at a repair shop as could be the ECU for example but do the fluid checks and go from ther ,keep me posted

May 09, 2014 | 2009 Hyundai Azera

1 Answer

Passat gear two ratio incorrect


This means that you have a problem in the shift solenoids of this electronically controlled transmission or a fault in the mechanical part of the transmission, this can be hydraulic fluid pressure loose or a defective valve body. In order to know the exact nature of the fault with 2nd gear some diagnostic testing must be done.

Feb 12, 2012 | 2006 Volkswagen Passat

2 Answers

What are the automatic transmission problem codes PO 751, PO 761, PO 734 indicate


PO 734 GEAR 4 INCORRECT RATIO
PO 751 SHIFT SOLENOID A PERF OR STUCK OFF
PO 761 SHIFT SOLENOID C PERF OR STUCK OFF

Jul 05, 2011 | Ford Focus Cars & Trucks

2 Answers

Ford trauras trouble code 732 - was told transmission code 732 was being produced, what does a code 732 say?


P0732 FORD - Incorrect Second Gear Ratio
Transmission in second gear and the ECM detected an incorrect gear ration. This diagnosis monitors actual gear position by checking the torque converter slip ratio calculated by Transmission Control Module (TCM) as follows:

Torque converter slip ratio = A x C/B

A: Output shaft revolution signal from revolution sensor
B: Engine speed signal from Engine Control Module (ECM)
C: Gear ratio determined as gear position which TCM supposes

If the actual gear position is higher than the position (2nd) supposed by TCM, the slip ratio will be more than normal. In case the ratio exceeds the specified value, TCM judges this diagnosis malfunction.

Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
- Incorrect transmission shifting

Possible causes
- Low transmission fluid level
- Dirty transmission fluid
- Shift solenoids
- Transmission mechanical problems
- Transmission hydraulic control circuit

Tech notes
Start by inspecting the transmission fluid level and condition, and change fluid if necessary.


Hope helps.

Apr 26, 2011 | Ford Taurus X Cars & Trucks

1 Answer

2001 Jeep Grand Cherokee won't shift out of first gear and the fault codes are P0733 and P0734.


P0733=Gear 3 Incorrect Ratio
P0734=Gear 4 Incorrect Ratio,
your transmission is in "limp" mode,
Have the following sensors checked on the transmission,input sensor,output sensor,and speed sensor.
The transmission is not getting a signal from one of them,So it doesn't know how fast your going so it doesn't up shift.

Jan 22, 2010 | 2002 Jeep Grand Cherokee

1 Answer

I have jeep liberty 2003 and it has gear 3and 4 incorrect ratio. the trany does not want to shift th higher gears- any advice what it could be?


faulty input speed sensor possible. sensors are fairly cheap and easy to install. no gaurentees because normally u will have more codes then just the 3-4 ratio with a faulty sensor but u may get lucky

Nov 19, 2009 | 2003 Jeep Liberty

2 Answers

P0734 Gear 4 Incorrect ratio


USUALLY WHEN ITS AN INCORRECT GEAR RATIO ITS USAULLY A INPUT SESOR AND IF THAT DOESNT FIX IT THEN TRANNY

Oct 06, 2009 | 2003 Ford Focus

1 Answer

02 jeep liberty won't shift into 3rd or 4th gear.


Ratio codes generally indicate a pressure loss & slipping which the computer reads as a gear ratio problem. Likely you need a rebuild.

Mar 16, 2009 | 2002 Jeep Liberty

1 Answer

2003 jeep liberty sport 4x4


It means that your transmission is probably slipping check your fluids and have you transmission filter changed also change your plugs your check engine lite should go out. Please rate me any further assistance you can always ask me. 1ak+f4pj7cbm32cuniyi2gaaaaaelftksuqmcc

Jul 20, 2008 | 2003 Jeep Liberty

Not finding what you are looking for?
2003 Jeep Liberty Logo

4,902 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...