Question about 1999 Nissan Pathfinder

1 Answer

Not nissan but daewoo matis?

Car keeping cutting out but the garage wants £500 to fix it they say a drive shaft is needed but thats a mechanical problem not an electrical do u know what could the problem? the car will start and go for 1hr then some times it wont start

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 962 Answers

It is probably a sensor. Such as the MAF, MAP, or the crankshaft position sensor. If you can get it scanned , they will give you the code to troubleshoot what the problem can be.

Posted on Nov 24, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My nissan D22 kingcab 2000 reg keeps brakingdown


The pump is in the tank for sure on this one. Check spark plugs/wires? Fuel pressure?

Jul 11, 2015 | Nissan Cars & Trucks

1 Answer

Hello I have a 2005 Nissian Sentra S it has recently started cutting off while I'm driving . I took the car to Auto Zone where I was given a code of P0335 which was a crank shaft sensor. I replac


Unfortunately, replacing a sensor only fixes the problem about half the time. The code means the computer is not getting a signal from the sensor, not that the sensor has failed.
The problem could be in the wiring, or the part that the sensor gets the signal from.

Feb 25, 2013 | 2005 Nissan Sentra

1 Answer

Vw golf cutting out


No it is impossible to say without testing the vehicle and doing a complete analysis with the correct diagnostic equipment.

These vehicle have numerous electrical faults that sometimes the VW dealer service centres cannot diagnose. What has been happening to you is the mechanics have been guessing what the problem is and just changing things without really identifying the actual cause - as you have now found. These are very unreliable cars so do not be fooled by the "german quality" label that people frequently and wrongly apply to German cars.

If you want and need a reliable car I would recommend you get rid of this Golf and get yourself a Mazda (and have any prospective used car thoroughly inspected before biuying). If you keep the Golf I guarantee it will give you much grief and cost you plenty more repairs.

Dec 21, 2012 | 2002 Volkswagen Golf

2 Answers

Clearing ABS light in Nissan primera


in most cases abs lights will go out after the problem is fixed but you can try to disconnect the battery for a few min

Aug 01, 2012 | 2003 Nissan Primera

1 Answer

What is a drive belt on a nissan pulsar, i was told on a mechanics list that it should be repaired immediately, i was wondering if i can do it myself!


Drive belt is a term used by some mechanics for the timing belt, which is usually replaced every 100,000km, less on some vehicles. It is the main belt which drives the cam shaft and the crank shaft in there correct sequence. You need to make sure all timing marks, on crank and cam shaft are aligned correctly when replacing it. I would not recommend doing this yourself as it can be costly (bending valves) if it is not installed correctly.

Feb 17, 2011 | Nissan Pulsar Cars & Trucks

1 Answer

4 x 4 is not engageing. Mechanic told me that the electronics are not lining up the gears in the tranfer case? stated they were out of alinement. 500.00 to fix?


take it to another garage......no gears need electronic alignment,in any car.(mind you, i could do with $500........)there is an electromagnetic switch for the transfer box,but that is not $500 to fit.
just thought...i could fly over from england,fix it,have a holiday,and fly back, for not a lot more than $500.

Jul 15, 2010 | GMC Sierra 1500HD Cars & Trucks

1 Answer

Oil leak


be patient they will find it

Jan 06, 2009 | 2000 Daewoo Leganza

1 Answer

Daewoo lanos not starting after renewing water pump


YOU DON'T HAVE THE TIMING CORRECT AT ALL. YOU DON'T HAVE IT TIMED RIGHT ON THE ENGINE. IF YOU KEEP TRYING TO START IT AND RUN IT, YOUR GOING TO CAUSE SEVERE VALVE DAMAGE TO YOUR ENGINE ... BENT VALVES. TAKE IT TO A SHOP AND HAVE THEM FIX THE PROBLEM BEFORE YOU MAKE IT WORSE.

Sep 05, 2008 | 1999 Daewoo Lanos

1 Answer

Crank shaft gone


if the crank shaft was bad it wouldnt turn over most likely, Crankshaft Position Sensor Possibly?

Jul 21, 2008 | 1999 Daewoo Nubira

2 Answers

86 T'bird with leaky main seal


on the 86' bird the engines are all mounted for rear wheel drive the problem is the seal is very touchy, you may have a grove on the crank . ford makes a seal kit with a new and improved seal. i know i own a 86' bird.

Jun 22, 2008 | 1986 Ford Thunderbird

Not finding what you are looking for?
1999 Nissan Pathfinder Logo

129 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...