Question about 2004 Mitsubishi Endeavor

2 Answers

2004 endeavor trunk

My 2004 endeavors trunk and lift gate wont open from the out side i have to climb in the trunk and open it with the safty latch

(i need help )

Posted by on

  • 3 more comments 
  • Anonymous Sep 02, 2008

    I have the exact same problem with my liftgate for the 2004 Endeavor

  • argutz Sep 22, 2008

    Same problem. 3 weeks ago the liftgate and rear window starting opening up only occasionally, then the window would not close (I closed it and it would pop itself open, had to hit lock at the same moment to keep it shut). Must be an electrical problem or with the security system. My general mechanic could not isolate the problem. Dealerships are a few hours away.

  • airmanx Nov 06, 2008

    I have the same problem, lift gate always locks shut and I need to crawl in to release it. I followed instructions and opened the cover and disconnected the small wihte connector that goes to the glass opening handle micro switch. Darn, still wouldn't open. Any other suggestions?

    Is there another micro switch that controls the door latch inside the back door panel? The panel looks almost impossible to remove.

    Thanks

  • Anonymous Jan 16, 2009

    I have the same problem.. I can;t open the glass form the inside, though. You said "and then open the glass from the inside as well" how do you do that?

  • Anonymous Mar 15, 2014

    2013 Dodge Avenger trunk latch wont lock, you hear it click.. we made sure nothing is in the way of the latch it still will catch or open up. This is the first time this has happen any clues to help

×

Ad

2 Answers

Today is your lucky day. Get inside of your vehicle to open the lift gate and then open the glass from the inside as well . From the outside of the vehicle with the gate down and the glass open you will see the cover on the glass held in place by two screws. Remove this cover to expose the micro switch for the glass opening handle. You will see a small white connector and with a little patience you can remove this connector. If the glass switch is bad your hatch will now open and your glass should close without having to lock the locks. The switch is a dealer item and goes for around $50 and a bit more dissassembly of window to replace switch/Handle. Happened to me and cost 100 just for them to tell me what was wrong. I used a stick to poke the safty latch for almost two yrs

Posted on Sep 27, 2008

  • Marion Beamish Dec 12, 2011

    I too currently have the same problem with my 2005 Endeavor trunck. It will not open with the door lock remote or via insde door. I have to reach from behind and pull the hidden lever. Although now it does not work.....it is off the shp tomorrow to pay who knows what to get it fixed......

×

Ad
  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Ok, if u do disconnect the window switch as described above and u cannot still open door, it is the latch, dealership wants 150 for new one, don't buy it, open up old one and if u notice a tiny piece of metal that makes contact with a chip(has the wires coming out of it), clean the metal with Dremel, or SOS pad, put it back in, ur good to go, to remove tailgate latch, open up tailgate, then first remove upper part of plastic molding around window, then your left with the bottom piece, their are 5 screws holding bottom piece on, then u have to remove the piece that holds the latch and licence plate lights, use 10 mm socket, there r 4 bolts, pop the ***** off, take it apart by popping the tabs, clean it and ur done, thank you and have a good day

Posted on Jul 04, 2012

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is there a way to reset keyless entry for 04 endeavor?


Search Results

    2004 Mitsubishi Endeavor Key Fob Remote Programming ...

    blog.keylessentryremotefob.com/.../04/2004-mitsubishi-endeavor-key-fo...
    Apr 25, 2013 - 2004 Mitsubishi Endeavor Key Fob Remote Programming Instructions ... you might have visit us at Keylessentryremotefob.com You can also ...

    Mitsubishi - Free Keyless Remote Fob Entry programming .

    How To Replace Mitsubishi Endeavor Key Fob Battery 2004 ...

    ? 2:04
    www.youtube.com/watch?v=yeQRdre7O0Q
    Oct 31, 2014 - Uploaded by Keyless Entry Remote Inc
    ... will show you How To Replace Mitsubishi Endeavor Key Fob Battery 2004 2005 To Order This Remote ...

Nov 01, 2015 | Cars & Trucks

2 Answers

Mitsubishi Endeavor 2004. 1. the tail gate and the tail gate glass do not open 2. the AC drains into the driver flooring instead of draining outside to the ground. Why? And where is the output drain...


The door and the glass just needs some penetrating lubricant( WD 40 ), just a few squirt will do on hinges and locks!
The drainage hose would be under the passenger side( RiGHT FRONT SiDE) glove box, look down there, u will see a black hose from the center that houses ur A/C & heater housing! Lift up ur floor covering to see it clearly. check and clean the hose it might already been clogged by moss and dirt or dislocated thru the drain holes on the flooring! Hope that helps out! Taah!

Nov 18, 2010 | 2004 Mitsubishi Endeavor

2 Answers

Does the 2004 mitsubishi endeavor have an MP3


The 2004 Mitsubishi Endeavor does not support MP3 playback or Ipod adapter. You would have to install an aftermarket stereo in the CD slot below the HVAC (A/C) controls.

Nov 24, 2009 | 2004 Mitsubishi Endeavor

1 Answer

Lift gate does not work in 2004 mit endeavor


This is due to the microswitch inside the glass hatch failing. It will not let you open the door because it is unsure if the glass is open or not.

Here is how to verify this:

Manually open the glass hatch.
Remove the two philips screws from the cover on the back of the handle area, and unscrew the plastic plug with the slot in it.
You should now be able to remove the cover.
You will see the harness coming off the glass handle going to a connector. Unplug this white two wire connector.
Your rear hatch should now open normally, just without glass opening.

To repair this, you will need to replace the glass hatch handle. It is a dealer-only part, and the cost is about $35.

To replace it, simply remove the 2 10mm nuts behind it (visible with the cover off that you just removed) and replace the handle and plug it back in.
Now all functions will work.

If you have any questions, just ask :)
If this has been helpful please be sure to rate me :)

Sep 16, 2009 | 2004 Mitsubishi Endeavor

1 Answer

Can a 2004 endeavor use 2003 montero lifters


I looked this up and got that a 2004 endeavor has a 3.8l and the 2003 montero has the 3.5l engine. the oil filters have different part numbers for each engine.

Jul 17, 2009 | 2004 Mitsubishi Endeavor

1 Answer

Describe your my Mitsubishi endeavor 2004 back door doesn't open Problem


Does this not open from inside or outside or both.
If it opens from the inside and not the outside look at the door opening near the latch. Look for the small lever "child-lock" just move the lever in the oposite direction.
If the door doesn't open from inside or outside I would ask has anyone try to unlock the car using a "slim-jim" if so they may have caused the lock rod to come off the latch on the inside. You'll need to remove the door trim panel and see the the rod has come off. With any luck it will just pop back on if the nothing is broken.

Jul 08, 2009 | 2004 Mitsubishi Endeavor

1 Answer

Cabin Air Filter - 2004 Mitsubishi Endeavor (Where?)


IT IS IN BEHIND THE GLOVE COMPARTMENT YOU HAVE TO TAKE IT OUT BY UNSREWING AND START FROM YOUR RIGHT SIDE

May 31, 2009 | 2004 Mitsubishi Endeavor

1 Answer

Lift gate wont open


OK, this minor collision may have shifted the actual clip and latch assembly. You may have to totally disassemble the latch assembly to release this lift gate.

Any kind of major or minor shifting of the lift gate lock latch assembly can cause misalignment that will jam this delicate precise locking mechanism.

Apr 23, 2009 | Jeep Grand Cherokee Cars & Trucks

Not finding what you are looking for?
2004 Mitsubishi Endeavor Logo

925 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...