Question about 1997 Saab 900

1 Answer

Hello, I need help with my 1990 9000 saab

Hi I need a picture of how this dang belt goes back on my 9000 saab 1990...
I thank you very much if you can help me

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 71 Answers

Hey

Is it the fan belt your after??
http://www.toronto-short-rental.com/images/Serp_belt2.jpg

Damien

Posted on Aug 22, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I need a pic of the belts of a 1990 saab 900


top picture is non-turbo bottom picture is a turbo model.

12_4_2011_2_01_44_pm.jpg12_4_2011_2_02_00_pm.jpg

Dec 04, 2011 | 1990 Saab 900 Hatchback

1 Answer

Need help I have a saab 93 convertable 2.0 i non turbo 1998 model drive belt has gone dont know where to find the ajuster to put the belt on. And a diagrame to see how it goes on.Regards James.


Here is a link to a Dayco PDF file that will have a belt diagram for you. Find you car on the main page, fine the number to the diagram and thats how you belt routes. Depends on month of manufacture yours could have 2 guide or tensioner pulleys. Facing the engine, one should be the top left pulley, that one is common to all. The optional tensioner will be the next pulley to the right. If one is missing it may have fallen off and you may be able to run a shorter belt.

Mar 02, 2011 | 2000 Saab 9-3 Viggen

1 Answer

Power steering belt snapped on saab 900 1996 battery light on


hi, you have to repalce it soon because the power steering belt also moves your alternator, the battery light on means that there is no charge, hope this helps.

Dec 21, 2010 | 1996 Saab 900

2 Answers

Hi, i need a diagram for saab93 5005 to know how


try typimng in diagrams on bing and than type in timing belt for your saab

Apr 07, 2010 | 2004 Saab 9-3

1 Answer

Having a problem with the belts on 1986 Saab.


There are four drive belts
  1. crankshaft to power steering pump
  2. crankshaft to a/c compressor belt idler pulley, to a/c compressor
  3. crankshaft to coolant pump, and
  4. crankshaft to alternator.
3 and 4 are side by side belts on the crankshaft, and each drive both the coolant pump and the alternator.
See this page for pictures of the belts, but I haven't a layout for them. The pulley grooves align for each of the different belts, so it shouldn't be too too difficult to figure out which is which.

Dec 21, 2009 | 1987 Saab 9000

1 Answer

1999 serpatine belt


Hi,the serpentine belt is tensioned automatically by means of a spring loaded tensioner,this is released by using a long 1/2 inch extension bar which fits into a square hole, once pulled back the tensioner can then be held by a nail etc, which is inserted into a hole which aligns with another hole,thus holding the tensioner back in a pre-loaded position to allow you to replace the belt,once replaced you can then pull back the extension bar to remove the nail again and then slowly let off the tension, IF replacing the tensioner, The new one comes pre-loaded with a pin in location to hold it ,hope this is of some help, Bill.

Feb 20, 2009 | 1999 Saab 9-5

1 Answer

2.3 900 se fan belt


The Saab fan is electrically controlled directly via the ECU and has no belt. I will therefore assume you are referring to the accessory belt that drives the power steering pump, the alternator, AC, etc. Pictures and step by step instructions are here and here. Both of these sites are also demonstrating the use of a shorter belt to bypass a center idler pulley that fails frequently (and that was eliminated altogether by Saab in the transition from new generation 900s to the first iteration of the 9-3 model).

Dec 22, 2008 | 1994 Saab 900

1 Answer

Tick over


you have a short somwhere try unplugging fuses and see if the power stops leaking to run down the short

Oct 21, 2008 | 1994 Saab 9000

2 Answers

I have a 1992 saab 9000 with a 2.3l turbo engine with a loose belt. i don't see an easy way to tighten. do you have a solution? Thanks, Den


hi den the 2.3 has a hydulic tensioner that is non ajustable if the belt is lose this will need replaceing

Oct 11, 2008 | Saab 9000 Cars & Trucks

Not finding what you are looking for?
1997 Saab 900 Logo

Related Topics:

132 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saab Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

yadayada
yadayada

Level 3 Expert

60792 Answers

rgbypoet

Level 2 Expert

161 Answers

Are you a Saab Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...