Question about Chevrolet Blazer

1 Answer

I have a 1994 4.3 vortec with 26,000 miles on because the motor was not used for 10years. I installed it in a 1988 toy truck and it runs good but the, Problem is- i think i have a stuck vaule because the driveside exhust is stucking in air. what can I do about this?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 2,920 Answers

You would need to have someone rebuild it or tear it down to get the valve loose again

Posted on Aug 22, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why won't it rev?


1997 GMC Jimmy 4.3 L Vortec - Discussion on Topix

www.topix.com > General Motors
Aug 17, 2009 - I have a 1994 S10 Blazer with 4.3 Vortec. ... Sometimes runs fine, or it barely moves and won't get out of it's own way all the .... Can rev up, dies. 1994 Silverado 5.7L TBI Engine Missing/Surging/Sputtering ...
Sep 27, 2013
2001 Jimmy transmission not shifting
Jul 5, 2009
More results from www.topix.com

Jan 04, 2016 | 1994 GMC Jimmy

1 Answer

I have a 1996 chevy silverado with a 4.3 vortec and manual transmission. What is the best or easiest vortec v8 to use to swap from v6 vortec to v8 vortec?


Thats a tough one, the computer problems are huge on swapping the v8 in.. If it was me I would use an older motor that's not running a computer..or a crate motor ...

Jun 05, 2014 | Cars & Trucks

1 Answer

1994 caprice vortec motor not getting gas


Does the fuel pump run? Does it start is you spray starting fluid into the intake hose?

Mar 21, 2014 | 1994 Chevrolet Caprice

1 Answer

I had a 1996 vortec v6 put into my 1994 vortec and it has not run good since can you help


The prom chip needs to match the motor...if you didn't change the chip in the computer, you need to do that.

Oct 20, 2009 | 1994 Chevrolet S-10 Blazer

1 Answer

My 1994 chevy s 10 blazer starts only in morning or after sitting for a long time(1 or 2 days) has new fule pump fule fliter fule presser is great have strong spark new plugs and wire relay is good motor...


I would definately check around the intake gaskets with any spray lubricant or cleaner.Do this while the engine is running. If it starts to stumble then concentrate the spray until you pinpoint the area of fault. This is all I have to offer without being there. Good luck,Dana

Aug 23, 2009 | 1994 Chevrolet S-10 Blazer

1 Answer

Custom buggy wrapped on Astro AWD


All depends on the 4.3 your going to install. The transmission are the same, that both use the 4L60E. E being that the transmission is controlled by a ECM with the engine. If your running a Aspirated 4.3 and not fuel injected, your going to have to run a 4L60 transmission. 
As for the AWD the new AWD system on the Astro works off the ABS system as it runs on 2WD till the PCM detects the lost of traction then the transfer case is activated by the ECM.
The earlier Astro and Safari AWD 1991 to 1994 had a true AWD and stayed active, but was not that great off road since it had a 40/60 split ratio front to back transfer.
Good luck and hope this helps.

May 25, 2009 | 1997 Chevrolet Astro

3 Answers

I have a chevy blazer 94 S10 still quit on the road.


How is it running before it quits onyou. This could be the culprit of an egr valve. How many miles on thevehicle. The egr seems to die on a certain mileage pattern. Also youcould start by cleaning the egr valve before replacing it. This couldvery well help the situation, but this is just a guess. Hope thishelps!!

Apr 30, 2009 | 1994 Chevrolet S-10 Blazer

3 Answers

Upgrade 4.3 l carb engine to vortec TFI fuel system


It can be done but it is very time consuming.
I use an 87 Astro van intake sensors and computer on my 86 OMC.
After six years I am still playing with it.
Runs good and easy on gas.
Got lots of info from DIY-EFI.
You HAVE to change programing in the computer.
I am running a closed loop system with one oxygen sensor in the starboard manifold.
Your 94 computer is not as good for a boat because it also controls the transmission.

Just to give you an idea what your in for.

Apr 01, 2009 | 1994 Chevrolet S-10

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...