Question about 1999 Ford F150 Regular Cab

1 Answer

Signal my signal does not wok. Want flash!

Posted by on

  • 1 more comment 
  • ronj2cool Aug 22, 2008

    how do i now if the relays click or ho wdo i make them click

  • ronj2cool Aug 22, 2008

    where is the flash relay located????

  • ronj2cool Aug 22, 2008

    i have a 99 f-150 tirtion xlt

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 71 Answers

Hey

Did you check all Your fuses? if there fine check all over your relays to see if they make a click when the hazards are on!

Damien

Posted on Aug 22, 2008

  • Damien R
    Damien R Aug 22, 2008

    hey again



    For a Bosch relay (as most are) the coil is between pins 85 (negative) and 86 (positive). The switched contacts are usually 30 (positive and 87 (and 87a), negative. Put a multimeter (set on resistance) or a circuit containing a battery and light bulb across the switch contacts and put 12V across the coil contacts. If it's working, the resistance should go from open circuit to zero, or the light should come on. Be very careful not to short anything. If you're using your car battery as the 12V source, a short will cause a really big bang.

    hope this helps you....

    the easy way is to just check it with a battery by joining + to +
    and - to - and listening for a little click!!!

    Damien

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The hazard back lights wont quit blinking when car is running even when i pull the fuse on a 2002 buick regal


What fuse are you pulling ?

Hazard Lamps
The hazard warning switch is part of the turn signal switch. The turn signal switch receives battery voltage at all times through the HAZARD SWITCH Fuse. When the hazard switch is placed in the HAZARD position, battery voltage is applied to the hazard lamp/turn signal lamp flasher. The hazard lamp/turn signal lamp flasher sends a turn signal flasher signal to the turn signal switch. The turn signal switch provides all of the turn lamps and turn indicators with the turn signal flasher signal, simultaneously flashing them on and off.

Turn Signal Lamps
The front turn signal lamps are made up of the front park/turn signal lamps and rear turn signal lamps. The front turn signal lamps flash with the rear turn signal lamps when a turn is initiated using the turn signal/multifunction lever. The turn signals will operate only with the ignition switch in the RUN position and will not operate during hazard flasher operation.
When the ignition is turned to the RUN position, battery voltage is supplied to the TURN SIGNAL Fuse. Battery voltage is then applied through the turn signal fuse circuit to the turn signal switch. When the turn signal switch is placed in the LH or RH position, voltage is supplied to the hazard lamp/turn signal lamp flasher. The hazard lamp/turn signal lamp flasher supplies a turn signal flasher signal to the turn signal switch. With the turn signal switch in the LH or RH position the corresponding turn signal indicator, rear turn signal, and front turn signal receive the turn signal switch signal and will flash. The front turn signals receive the turn signal switch signal from the turn signal switch via the BCM. The turn lamps are permanently grounded.

Replace the turn signal switch. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle in Steering Wheel and Column - Tilt.

Feb 11, 2017 | Buick Cars & Trucks

1 Answer

Door locks will not work


The door locks are controlled through the vehicles body control module is my understanding, so what needs to be done is to have the BCM scanned and an active test run to see what comes back on faults.

Oct 01, 2016 | 2009 Honda Odyssey

2 Answers

02 Buick LeSabre Ltd. Rear flashers work (blinking rapidly), front bulbs stay on, inside indicators also flash rapidly. Replaced control module under the dash. Did not help. What else could it be?


Hi there., when flashers/indicators work rapidly on the dashboard you should check whether it is the same on the actual bulds. Fadt flashing is usually a sign of a bulb failure somewhere. If everything is functioning ok externally I would consult a competent technician for a diagnosis.

Jun 08, 2015 | 2002 Buick LeSabre

1 Answer

Having trouble with a 2010 tiguan . low beam right waring came on as well as rear left signal. I changed the front low beam warning still there and light doesn't wok. What is my next step?


Check grounding on the fixture. Usually the fixture only gets the 12v+ from switch. The 12v- comes from the fixtures mounting or it has a black wire that comes off of fixture and goes to ground.

Dec 28, 2012 | 2010 Volkswagen Tiguan

1 Answer

Brake/Signal Lights Problem.


Sounds like a ground problem to me. Bulbs are not getting there ground to complete the circuit so they backfed through the other bulbs.

Oct 23, 2012 | 1998 Acura RL 3.5

2 Answers

My 2001 Jeep Cherokee turn signals don't always work. When they do, they work for a little while and then stop flashing. Any ideas?


just change your hazard/turn signal relay, yesterday i replace the relay on my JGC2001 and it woks good...

Dec 30, 2010 | 2001 Jeep Cherokee

Not finding what you are looking for?
1999 Ford F150 Regular Cab Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

71856 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22082 Answers

Ron Lankford

Level 3 Expert

5386 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...