Question about 1999 Jeep Grand Cherokee

2 Answers

'99 Jeep Grand Cherokee Termination Block Issues

On the passenger right side foot area, behind the panel, there is a three piece termination block. The piece mounted to the wall has two others that use a bolt and some type of internal plastic clip to secure them to the initial. How can I get these pieces apart since the bolt, that is supposed to allow for these plastic clips to seperate, comes out completely rather than function properly?

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,268 Answers

Try to take out the whole parts completely first and from there, separate the bolts.

Posted on Aug 22, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,450 Answers

With the bolt out it should pull apart.

Posted on Aug 22, 2008

  • TripleTauto
    TripleTauto Aug 22, 2008

    the bolt is what holds it in place.so if that unscrews it should be released try and gently wiggle it apart

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where do I find the block heater on my 2006 Jeep Grand Cherokee?


The location of your block heater depends on which motor you have. If you have a 4.7L motor it is on the rear frost plug location on the right side of the engine (passenger side).


raineman_15_16.gif If you are installing a new one notice the direction the block heater points when it goes into the block (upwards).

If you have a 3.7L engine it looks like it is on the same side of the engine except that is is in the first frost plug location. Here is a picture of it.


raineman_15_17.gif
Now if I understood your question wrong and you are just looking for the block hearts cord, open the hood and check inside the engine compartment or look agound your grill and front bumper area.

Good Luck

Dec 17, 2010 | 2006 Jeep Grand Cherokee

1 Answer

Where is the fuse box for the 1999 Jeep Grand Cherokee Laredo


I have a 2000 but the 99 is probably the same. Mine is on the passengers side front seat area under the glove box. Youll need to remove the access panel of course. There are also fuses located under the hood on the passengers side.

Dec 02, 2010 | 1999 Jeep Cherokee

1 Answer

Radio fuse for 94 grand cherokee


Cavity number 10 in the fuse block. Right side (passenger side), inside vehicle under clove box area.

Aug 26, 2010 | 1994 Jeep Grand Cherokee

2 Answers

Where is the oil pressure sending unit on a 1993 jeep grand


on the 4.0 motor Under hood, passenger side, lower engine area, rear of distributor, mounted in engine block.
on the v8 Under hood, center, rear engine area, passenger side of distributor, mounted in block.

Feb 09, 2010 | 1994 Jeep Grand Cherokee

2 Answers

I need to find the fuse box for a 1996 jeep grand cherokee limited


In here you can find the location of the Fuse Box, Power Center Distribution and other parts about the electrical system: ZJ-Secc-8W-Wiring-Diagrams (Module & Componentes Location / Page 10, Fig. 16)

I hope help you with this, good luck (rated this help).

Aug 30, 2009 | 1996 Jeep Grand Cherokee

1 Answer

All windows and door locks went at once


I have a 1996 jeep grand cherokee and the fuse panel is over on the passenger side and the fuse compartment is cavity k for the door controls. Don't know if this will help or not. There is a little indent at the bottom that you just push and pull. Good luck

Jul 08, 2009 | 1995 Jeep Grand Cherokee

1 Answer

1995 Grand Jeep Cherokee


The lower speeds are controlled by a resistor block. That's what needs to be replace. It's usually located next to the blower. It will have electrical wires connected to it. High speed bypasses the block so it alway works.
If you want to replace it then;
) Disconnect the battery negative terminal if the vehicle have air bags. Wait 2 minutes for system to discharge.
) Remove the kick block on the passenger side. )Remve the glove box ) Remove the bolts holding the blower motor resistor. Push the red lock up and press down on the click ) Pull the block out. ) Install new block and reverse steps above.

Apr 13, 2009 | 1995 Jeep Grand Cherokee

3 Answers

Brakelight dysfunction


Try swapping the socket with the one from the other side if the problem goes to the opposite side then replace the socket

Aug 17, 2008 | 2000 Jeep Grand Cherokee

Not finding what you are looking for?
1999 Jeep Grand Cherokee Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

61292 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...