Need a diagram of location of thermostat housing

http://j.gs/694045/thermostat-video-tutorial

Hello. Here a non-photo diagram. Hope this helps!!!

The thermostat is located on the side of the water pump, the water pump is located just above the a/c compressor, the thermostat is fed coolant from the radiators lower radiator hose.
Thermostat :
1. drain coolant and tighten drain plug ( easier method : remove radiator cap, get big drain pan, place drain pan under lower radiator hose to radiator connection, remove clamp, slowly remove hose, allow coolant to drain into pan, now is a good time to remove radiator hose and clamp from thermostat housing )
2. remove thermostat cover / cap ( easiest to get at this when front of car is supported by jack stands and right hand side lower cover is removed ).
3. thermostat cap is held on by 3 bolts / remove thermostat.

You will notice that the thermostat's air bleed hole is pointing up and lines up with notch in water pump housing,,

ATTENTION :failure to install new thermostat in the correct location will cause engine to overheat.

1. install new thermostat to water pump, make sure air bleed hole lines up with notch, install and tighten bolts, install a new lower radiator hose, fill cooling system.

thermostat # 17670-77E00
lower radiator hose #17854-65G20
hose clamp #09401-36403
upper radiator hose # 17852-65G20

Suzuki factory manual

Hi.

1. Locate the thermostat housing. The housing can be found following the radiator hose toward the engine. The housing is located on the engine.
2. Remove the three screws that hold the thermostat housing.
3. Replace the thermostat.

Note. The thermostat spring goes toward the engine, the other side toward the radiator.

Here a diagram:



Regards.

Ginko

there are no diagrams for the location of the thermostat, just follow the top radiator hose to the motor and there will be a metal housing that the hose is clamped to thats the thermostat housing.

Check this location diagrams...



Fig. Exploded view of the thermostat (3) showing the thermostat housing (1,2) location on the engine block (4)-3.7L & 4.7L engines




Fig. Exploded view of the thermostat housing (2) and mounting bolts (1), lower radiator hose (4) and hose clamp (3)-5.7L engine

I hope this helps (remember to comment and rate this answer).

Heres a couple of pictures to help you locate the thermostat housing, if you follow the lower hose from the radiator to the motor you will find the thermostat housing on the block, remove the two bolts and off comes the housing and thermostat, hope this helps.

Heres a diagram of the thermostat location, if you follow the lower rad hose to motor that where the thermostat housing is remove the housing and thermostat is behind it. hope this helps.

FOLLOW COOLANT INLET OR RADIATOR HOSE TO ENGINE CYLINDER HEAD TO THERMOSTAT HOUSING OR ON BOTTOM OF WATER PUMP THERMOSTAT SOME TIMES LOCATED. DEPENDS WHAT TYPE OF VECHICLE YOU WORKING ON YOU DID NOT NAME VECHICLE TYPE.

Hello,\ The thermostat is located in the thermostat housing at the engine side end of the upper radiator hose. You have to drain the engine coolant from the radiator until it is below the level of where the thermostat is.

HTH, Mike...

Follow the top radiator hose to the engine. This is where the thermostat housing is located. Remove the bolts and take out the thermostat. When you get your new thermostat, get one from Autozone with a jiggle valve. The jiggle valve should be oriented near the top of the housing (the thermostat is not perfectly round, you'll have to play with it a little to get it to seat). Install with the spring side facing the engine and the gasket on the engine side of the housing. You can use some spray adhesive to keep the gasket in place while you install the thermostat.