Question about 2004 Dodge Caravan

1 Answer

2004 dodge caravan

I cant find the second bolt to take the starter off i found one but cant find the other.

Posted by on

1 Answer

Take out transmission

Posted on Oct 17, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I'm looking for the starter bolt pattern on a 2001 Dodge Caravan


Starter bolt "pattern"? I'm afraid I am not sure exactly what you are asking for. If you need specific instructions on how to remove and install a starter, it would be very helpful if you would let me know what engine we are talking about....A 2001 Dodge Caravan can be equipped with a 2.4L, a 3.3L, or a 3.8L engine.

Jun 26, 2011 | 2001 Dodge Grand Caravan

1 Answer

Is it fairly simple to change a starter on a 2004 dodge grand caravan? and about how long does it take?


Usually a starter is two bolts, you just have to unbolt them, get the starter out, and put it back. It takes ~3 hours, first time, mostly because you've got to line it up, it's heavy, and get it just right to put the bolts back in.

Dec 18, 2010 | Dodge Grand Caravan Cars & Trucks

1 Answer

HOW DO I REMOVE STARTER FROM 1999 DODGE CARAVAN SE 3.3


If the 95 is anything like the 90, the bolts are right on the flange type part of the starter, where the starter meets the transmisison. there is 3 bolts holding it in. they are most likely 13mm, 14mm, or 15mm bolts. but on some caravan models you have to remove the front transmission mount to get to it. this is probabally why you cant find em'. but you will have to remove the mount, then the starter bolts. then you have your starter out! but when you want to put the mount back in, you may need a floor jack to lift the engine/trans um into the right spot to put the bolt back through the rubber part. Tricky, but possible.

May 31, 2010 | 1995 Dodge Caravan

1 Answer

I nedd to replace the starter on a 2004 Dodge Caravan. I don't know where it is located or how to go about it.


The started is located on the back side of engine (firewall side) next to the transmission bellhousing. To remove starter first disconnect the negative battery wire from battery.Raise the front of van up and use jackstands to support the van,block the rear tires. From under the van remove the solenoid wire from starter. Remove bolts from starter and remove starter from van. Installation is the reverse the removal. Hope this will help.

May 21, 2010 | 2004 Dodge Caravan

1 Answer

I need to replace the starter on my 2001 dodge caravan sport. Where would I find instructions?


Caravan, Grand Voyager, Town and Country, Voyager, 2000-2004
Starter - Removal & Installation
  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Remove or disconnect the following:
    Negative battery cable Starter harness connectors Starter motor
To install:
Install or connect the following:
Starter motor. Torque the bolts to 35 ft. lbs. (47 Nm). Starter harness connectors. Torque the battery cable nut to 100 inch lbs. (11 Nm). Negative battery cable


Hope this help (remember comment and rated this).

May 14, 2010 | 2001 Dodge Caravan

1 Answer

Replacing the starter on 2001 Dodge Grand Caravan


with most front wheel drives you must remove the passenger tire and reach through to the starter bolt with an extension and if I remember write with a 15 mm socket you can reach through and take out the bolt

Jun 20, 2009 | 2001 Dodge Caravan

1 Answer

Locate bolts to remove the strater of 1996 dodge caravan


Almost all starters have ears with holds in them that bolts go through to threaded holes in the bell housing. Find the starter and look around the end without the wires for the bolts.

May 07, 2009 | 1996 Dodge Caravan

1 Answer

Starter removal and fix.


its probly the selnoid on the starter there should be 2 15mm bolts that go though the bell housing to hold it on and the wires. hope this helps

May 03, 2009 | 2004 Dodge Caravan

1 Answer

Trying to find the location of the starter


Try looking on the front side of the engine between the oil filter and transmission.

Removal & Installation
  1. Remove or disconnect the following:
    • Negative battery cable
    • Starter harness connectors
    • Starter motor
To install:
  1. Install or connect the following:
    • Starter motor. Torque the bolts to 35 ft. lbs. (47 Nm).
    • Starter harness connectors. Torque the battery cable nut to 100 inch lbs. (11 Nm).
    • Negative battery cable

Jul 25, 2008 | 2000 Dodge Grand Caravan

2 Answers

Starter for dodge caravan 2000


DISCONNECT THE BATTERY, JACK UP AND SUPPORT YOUR CARAVAN. LYING ON YOUR BACK LOCATE THE STARTER WHICH IS ATTACHED TO THE ENGINE THROUGH THE BELL HOUSING .THERE ARE TWO 15 MILIMETER BOLTS THAT HOLDS THE STARTER ON . AFTER BREAKING THE BOLTS A 15MM WRENCH WOULD BE USEFUL.

May 17, 2008 | 2000 Dodge Caravan

Not finding what you are looking for?
2004 Dodge Caravan Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...