Question about 1998 Chevrolet Cavalier

1 Answer

Chevy cavalier i have a 1998 cavalier and i have replaced the ignition control module 2 times and now it gets hot and wont start but if i let it cool down for a couple of hours it will start

Posted by on

  • D B May 11, 2010

    Does it crank but not start when its warm or not crank at all.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

Try to replace the TPS or the IAC. It just might not be getting enough fuel or it is getting too much fuel.

Posted on Aug 27, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1998 chevy cavalier where is the BCM (body control module) located?


Kimberley, 1998 cavalier, BCM is located at the lower left side kick/trim panel, you can have it checked and reprogrammed by a good Tech. as long as they have access to the programming software. Remember the BCM has to be reprogrammed if you change it.
Did you try the security relearn procedure, see 2nd and 3rd link for instructions on relearn procedure. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
2001 Cavalier won start the BCM RFA clicks
1998 Chevy Cavalier 1998 Chevy Cavalier Ok We Turned This in to
Fix Your Chevy With Your Own Hand

Jul 22, 2016 | Cars & Trucks

1 Answer

1998 chevy cavalier replaced ignition cylinder instrument panel stereo car wont start when its cold


You have a short to ground inside the steering column Measure voltage with ignition off.any wire that has less than 12 volts should be considered as problem if not black in color

Mar 19, 2014 | 1998 Chevrolet Cavalier

1 Answer

I have a 2003 chevy cavalier with a 2.2 4cyl engine. I replaced the fuel filter and it is still not getting any gas up to the front. I think it is the fuel pump, because the fuses and relays are good,...


no but the ignition module control the primary circuit of coil but at the same time tell PCM the engine rpm and then give signal to injector to spray
do you hear the pump working while key on engine off for 2 sec then while cranking have someone listen at tank fuel cap off

Oct 15, 2013 | 2004 Chevrolet Cavalier

1 Answer

1998 cavalier wont start no spark


If you have no spark try the ignition module, it controls the spark and if you don't have any and the coil is new its the only other option short of wiring or ecu!!

Nov 11, 2011 | 1998 Chevrolet Cavalier

1 Answer

I have a 91 chevy cavalier it runs until it gets warm then starts to shake and sputter then it stalls wont start again for couple hrs what it wrong with it


This sounds like a bad control module, this is an ignition control module and it sounds like when it heats up it goes bad until it cools down, if you remove it ,there are many auto part stores that will test it for you, but make sure its tested a few times so it heats up good,

Oct 13, 2010 | 1991 Chevrolet Cavalier

1 Answer

Control module 03 chevy cavalier 2.2l


2003 Cavalier's are known for bad wiring harnesses. Get a good technician to find and replace the bad harness and your problems will go away. Sometimes, it may be more than one harness.

Mar 14, 2009 | 2003 Chevrolet Cavalier

2 Answers

03 chevy cavalier 2.2l,what are the symptoms of a ignition control module going bad?


No Start, no spark. Also dies when hot, No start until it cools. no spark.

Mar 14, 2009 | 2003 Chevrolet Cavalier

2 Answers

1993 Chevy Cavalier 2.2 wont start


Have you had the Starter Checked out?

Jan 02, 2009 | 1999 Chevrolet K1500

1 Answer

92 chevy wont start


i'm assuming the car ran before the sensor? if so check the plug on the ignition control module

Sep 27, 2008 | 1992 Chevrolet Cavalier

Not finding what you are looking for?
1998 Chevrolet Cavalier Logo

333 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

64052 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...