CHRYSLER TOWN & COUNTRY MINI_VAN::::::: The windshield gasket on the lower part of the windshield is DRY & BRITTLE. This is the seal that fits on the cover that has the windshield washers perturbing out the top. I think that this problem is part of the cause of the windshield leaking........HOW do you replace it and what is the part number?

SOURCE: where is low side of air conditioning unit, so I

FOLLOW THE TWO LINES COMING OFF THE AC COMPRESSOR THEY BOTH HAVE FITTINGS FOR CHARGING THE BIG ONE IS THE LOW SIDE THE SMALL ONE IS FOR VACUMING THE SYSTEM OUT

SOURCE: rear windshield wiper blade doesn't hit rear

the pivot pin must be rusted to the point it does not want to move, try lubing it with wd40 or equivalent lube,at the bottom of the wiper arm just before the bolt that holds it to the car is the pivot point.that's where it has to be lubed.

Testimonial: " Thank you for the information. Will give it a try."

Marvin

• 85242 Answers
• Posted on Jan 19, 2010

SOURCE: where is the windshield washer pump located on a

it is part of the washer fluid resovior.

SOURCE: where is the windshield washer pump located on a 2000 chrysler to

in the bottom of the washer tank

SOURCE: CHRYSLER town and country mini van turn signal/flasher

I have a 2005 Chrysler T&C. The turn signal would not work at all or activate incorrect side. The switch is easy to remove as described by dukecityman.

Once the switch is of, it has four screws holding it together.I took this apart to find that there was a circuit-board which was contaminated with dirt. wiped it of, put it back together, working fine.

If you take it apart use caution. there are parts on the "top" which will fall out. ( they go right back in) The circuit-board is on the "bottom" half. You really only need to take this part off. (less moving parts)

Your going to replace it anyway, whats the harm?