Question about 2006 Mitsubishi Colt

Open Question

Mitsubishi colt 2007 1.3 automatic

I have problem getting into reverse gear. This appears most when the car is cold. I have tried everything but no luck.

Posted by on

  • vtxracer Aug 20, 2008

    Mitsubishi colt AMT 6 speed 2007 reverse problem

  • vtxracer Jul 02, 2009

    Ok, problem solved. I selled this s*** and bought a seat ibiza cupra tsi dsg.

×

5 Suggested Answers

  • 432 Answers

SOURCE: what type of oil for Mitsubishi Colt gear box

First drain completely out whatever is in it. All the gear boxes and rear ends use 90w gear oil. Buy a name brand.Some of the really cheap stuff is recycled used oil.
I hope this helps you.

Posted on Sep 11, 2009

  • 1 Answer

SOURCE: Mitsubishi Colt Cz3 1.3 2008 start problem in a cold seasons

This dosen't help but.........
I have a similar problem. Every 4 weeks or so the car refuses to start. Again battery is not a problem but if we use cables to jump start from another car it starts fine.
Mitubishi cannot find the answer, only suggestion was to spend £150 on a new key , however the problem has now occured with both of the keys !

Posted on Mar 04, 2010

  • 1 Answer

SOURCE: Porsche 944 '86: reverse gear in automatic transmission is hard,

my car wont rev past 4500rpm when in motion,

Posted on Mar 28, 2010

  • 1 Answer

SOURCE: Mitsubishi Pajero Junior Automatic Gearbox Problem

I have a pajero junior 1997 4A31, I am having problems, with my gear, when take off in D the car is slow, and up hill no power in 2nd & D, in Load ok. Plse advise. Thank you.

Posted on Jul 23, 2010

  • 1 Answer

SOURCE: Gear lever stiff and does not return to the centre

Hi, Permanant fix, take to garage and get them to replace link shaft on gear change mechanism. Or temp fix, get a tin of WD 40 with the plastic pipe that can be pushed onto the spray nozzle. Get a chopstick or simillar. Put chopstick down side of gear rubber gater. Do this by pulling blue rubber gater away from gear knob and gently inserting chopstick down into gater. Put the WD 40 plastic pipe down gater alongside the chopstick and spray a good amount. then roll the chopstick around to another possition and spray more WD 40. repeat until you have done it four or five possitions covering all round. Job done.

Posted on Aug 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Auto gearbox gets stuck in reverse gear.


This is likely a sticking valve in the transmission valve body assembly, try adding a can of Lucas brand transmission additive.

Jun 14, 2012 | Cars & Trucks

1 Answer

Car turns off when put in reverse or drive in the mornings,its an automatic,a golf III Volkswagen


This is a common problem with alot of other makes of cars, it has to do with the air fuel mixture when the car is cold these settings are changed under normal operating temperature by the ECM to make the engine run normally when it is not at optimal running temp. The cause of the engine to stall when in put into reverse is the reverse gear in any car is geared higher then forward first gear so the engine has to work harder to move the vehicle and with a cold engine if the engine is not 100% tuned (proper maintenance and tune up) it will stall when cold and specially when put into reverse. This is a very difficult problem to diagnose and only a highly skilled vdub mechanic working on your car can fix this. I could tell you 8 different things you could try but they may not work, its kinda trail and error. Hope this helps

vdubs 4-ever

Sep 09, 2009 | 1996 Volkswagen Golf

5 Answers

VW sharan auto gearbox will not engage in reverse.


Your reverse band is gone, any gearbox specialist can do this but cost about £500-£600, Good luck

Jul 09, 2009 | 2001 Volkswagen Passat

2 Answers

1993 FORD CROWN VICTORIA has no reverse gear when engine warm.


No band for reverse,sounds like you have a trans. in need of repair.

Jan 22, 2009 | 1993 Ford Crown Victoria

1 Answer

Manual transmission at times has trouble shifting


2003 hyundai, should only have hyundai approved fluids in both the cooling system and transmission. If you take your vehicle to a transmission shop other that hyundai let them now there is a special fluid that goes back into the either radiator or transmission. Regular transmission fluids viscosity is to thick and will make shifting very hard. My Mazda has the same issues Wrong fluids go back into the transmission when I have had work done to it making the shifter hard to shift in cold weather. A Worn clutch can have the same effect.

Jan 19, 2009 | 2003 Hyundai Santa Fe

1 Answer

Have a hard get the gear shift to go into reverse


if it will not shift out of park when the brake is pushed then in will be the shift interlock, but if it is still hard to move after out of park then it will be a shift cable

Jan 16, 2009 | 1998 Chevrolet Blazer

Not finding what you are looking for?
2006 Mitsubishi Colt Logo

Related Topics:

515 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

69199 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22026 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6817 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...