SOURCE: 2000 jeep cherokee starts then stalls in approx 3 sec 4.0 has new crank sensor
I am going to assume that it will not run even if you push on the accelerator pedal?
Can you install or attach an old timing light to the spark plug wires, turn it one and try to start it. The light should flash with the engine running, but if it shuts off at time of engine die, and the engine is still spinning, you are losing spark, My suggestion is the cranks shaft sensor on bell housing.
Second, install a pressure gage on the test port on the fuel rail and watch it as you start the engine, fuel pressure should not drop as the engine dies, if it does, the pump is not working correctly. There are two modes of power to that pump, one to start and timed, for only a few seconds to prime the system, and one to run continuously. Find the wires going to the pump at the tank. Connect test light to those wires and watch what happens during crank and at stall, You should not have the pump shut off and the engine dies.
If you have spark, and fuel pump working, when did you last change the filter,,but I put that LAST.
It has to be one or the other of these.
Good Luck
SOURCE: 1997 Jeep Grand Cherokee Stalling
Best thing to check is your fuel filter. After sitting for a little while, it will allow fuel through it but when you put a demand on the system, it cant supply enough and will sputter and die. Its easy to replace and very inexpensive. If it continues after that, you will at least know it was eliminated and can move from there.
SOURCE: rough idle stalls at low rpm's
check your transmission fluid,the motor will stall when fluid is low
SOURCE: steps to replace fuel pump on 1999 jeep cherokee laredo 4wheel dr
how are the spark plugs?
would start with those.
the fuel filter is usually located under the hood by the intake manifold and attached to the firewall of the car. the pump is located right by the fuel tank and if you cant see it then its inside the fuel tank. (you will have to lower the fuel tank down to get to the pump.)
SOURCE: I put my jeep in reverse and it stalls. When i put it in drive it
check your plug wires and it wouldnt urt to check the distibutor car and rotor
232 views
Usually answered in minutes!
×