Question about 2002 Buick Rendezvous

3 Answers

Buick rendevousz headaches

I own a 2002 buick rendevousz and when i press the brake the engine turn off and i have to restarted again. on top of that the awd light is on the mechanic said is only driving in 2 wheel when is suppost to be driving in 4. but he doesn't know why the engine suddenly stop i took it to 2 different mechanics but they couln't find the problem. also the anti-lock light is on. can u help me?

Posted by on

  • 2 more comments 
  • Anonymous Dec 01, 2008

    Who made these cars the devil himself ?

  • fayparis Dec 04, 2008

    1 have a 202 buick rendezvous , the traction light stay and the antilock light stay on, it wount start i put new altinator and new battery still not starting with out jump start.................help please

  • dhmglass Apr 16, 2009

    I own a 2003 Rendezvous and have had the anti lock brake light and ABS disabled intermittently for about 8 months. I have taken it to have brakes looked at. First replaced front brakes, then rear brakes. It groans when I apply brakes especially backing up and often brakes are hard to apply. Now the light comes on and there is no more noise but can't stand notknowing how brakes will work.

  • Rickyrendezv May 06, 2009

    What is up with the hubs. Rears cost me $800 and seems like everybody is having front trouble. Jacked it up and spins fine not wobbling. Moaning from rear differential.

×

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

I own the 2002 Buick Rendezvous CX and I've encountered the same problems listed here. The ABS / Traction Control Lamp stays on and was throwing a code for the left wheel speed sensor as well as an anti-lock brake code (both in the wheel bearing hub assembly). I replaced the left and right front wheel hub assembly yet this did not eliminate the abs codes. 
Ultimately, I traced this problem to a break in the wire that leads to the left hub assembly. Although the sensor was properly connected, the wire (which is encased in a plastic housing) was broken. This is the wiring which leads from the abs wiring harness under the hood down to the left wheel abs sensor. 
I would suggest that you simply remove the left wheel and inspect the wire that leads to the abs sensor (there is only one wire on each wheel). Mine literally fell apart when I removed the plastic housing around the wire. I spliced the wire together and put it back in the plastic housing. After this, my abs codes disappeared and my anti-lock brakes began working again!
This is a simple fix that many people spend $1000 + on by replacing the hub assembly which does not fix the problem.

Posted on Mar 24, 2009

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Ge rid of the 2002 buick rendezvous it is junk!!! it is no wonder why General Motors is in the toilet!!

Posted on Jun 13, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 335 Answers

Bulletin No.: 03-05-25-004A
Date: April 14, 2004
TECHNICAL
Subject:
ABS and/or Traction Control Lamp On, AWD Disabled Message Displayed, DTCs Set (Replace Front Wheel Bearing and Hub Assembly)
Models:
2002-2004 Buick Rendezvous
2002-2004 Chevrolet Venture
2002-2004 Oldsmobile Silhouette
2002-2004 Pontiac Aztek, Montana
with All Wheel Drive
Supercede:
This bulletin is being revised to change part number information and update the model years. Please discard Corporate Bulletin Number 03-05-25-004 (Section OS - Brakes).
Condition
Some customers may comment that the ABS and/or traction control system lamp is illuminated. Also, the AWD disabled message may be displayed. Upon investigation, the technician may find several DTCs set.
Correction
When normal diagnosis leads to the wheel speed sensor as the suspect component, replace the front wheel bearing and hub assembly, P/N 89047684. Refer to the Wheel Bearing/Hub Replacement procedure in the Front Suspension sub-section of the Service Manual. This new part has 6 mm (0.236 in) added to the harness to prevent any stress to the wiring.
Hope this helps if so please give me a fixya and contact me about the shutting off I did not have enough room here.
fixincars@yahoo.com

Posted on Aug 20, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2002 buick is making a knocking noise from the front left wheel and its not the tire's


it is probably the hub bearing or drive axle shaft you can pull the code to see which side it is on,as far as check engine light again need to pull codes you can get it done at a local shop for a charge

Jun 14, 2015 | 2002 Buick Century

1 Answer

Brake warning light


a few scenarios can cause this light to come on, the level of brake fluid in the brake reservoir, normally located in the engine compartment, if this is topped up, check the handbrake switch maybe jammed in the closed position and lastly check the brake disk pads front and back for wear.

Feb 03, 2014 | Buick Cars & Trucks

1 Answer

Po102 mass air flow low input


Replace the air filter its clogged.

Nov 02, 2012 | 2002 Buick LeSabre

1 Answer

My 2002 buick century brake light will not go off, brand new brakes, also abs check engine light is on, put on computer showing nothing


The parking brake switch might be stuck, have it checked out. is the brake releasing all the way?

Aug 23, 2011 | 2002 Buick Century

1 Answer

When passing the car continued to accelerate , had to stand on brake engine conntiued to race and was shut down, engine restarted with no appearent damage. but we are now totally unsure about driving the...


If you are not at least a shade tree mechanic, i recommend that you find a mechanic to take a look at the throttle linkage for obstructions or other abnormalities, and also to take a look at the pedal, because sometimes a dangling cable from the dashboard, or the floor mat can jam the pedal. You are right about being cautious over driving the car to the shop.

Jun 16, 2011 | 2002 Buick LeSabre

1 Answer

2002 buick century heater resistor burning out


Sounds like something is drawing too much current for the resistor. Maybe blower motor going bad....

Apr 02, 2009 | 2002 Buick Century

1 Answer

2002 buick rendevousz


more than likely it is the ignition control modual until it goes all the way bad there really isnt a way to test for it

Aug 14, 2008 | 2002 Buick Rendezvous

Not finding what you are looking for?
2002 Buick Rendezvous Logo

3,122 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...