Question about 2002 Jaguar X-Type

1 Answer

Key pad I replaced the battery in both keys however electronic door locks and panic button still not working. Is there a fuse that needs replacing?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

Ugh..

Take a deep breath....THEN go to the dealership. I just came from there and it cost $150 to have the key reprogrammed. It takes an hour.

I'm still going to search online for instructions...

Posted on Aug 20, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why cant I unlock my Murano with the key or the fob?


replace the latch or chek latch cables or link from lock cyldr

Aug 27, 2014 | 2003 Nissan Murano

1 Answer

My 2004 Chevy key fob won't unlock the car doors....the lock button works just not the unlock. I replaced battery, try to clean the connections but it still doesn't work. What else can I try?


Open the key fob,behind the plastic pad put smalls aluminum foil
in between the pad and the circuit board of the key fob put separate in each hole close the fob and try

Apr 10, 2014 | 2004 Chevrolet Malibu Maxx

1 Answer

The key pads will not lock, unlock, or remote start. the panic button and trunk button work. is there an easy fix? Have replaced batteries.


open the remote and check to see if something needs re attatched... should be a quick fix for someone with a "sauder" gun

Jan 12, 2010 | 2006 Pontiac G6

1 Answer

Unlock button doesn't work


check power door lock relay and or fuse if both of these are good then the actuator is bad. most likely fuse or relay since everything is dead

Nov 15, 2009 | 2007 Toyota Corolla

1 Answer

2005 Dodge Dakota alarm and key pad trouble


No i do not think you have electrical problem, try this.

Car in Park
Key on
push and hold unlock on good remote for 5 to 10 seconds
while holding unlock, press and hold panic, then release together
Listen for chime
press and release any button on all remote to be programmed.

If this will not work you need to bring the Vin# and remote to a dealer for reprogramming.

Aug 09, 2009 | 1997 Dodge Dakota

3 Answers

Unlock button on key won't work.The lock button doesn't work either. We have to put the key in the door to unlock and push the button down to lock the doors.


Sounds like the button in the master switch, as all power must go through there. Also open door and between the door and jamb there will be a harness wiggle that while trying us the lock button, wires are known to brake there.

Aug 02, 2009 | 2005 Chrysler Town & Country

7 Answers

2006 bmw 325i remote only unlocks driverside door. will not unlock all doors when you lock it from the inside. have to use key in remote to open door. also central button to unlock doors is inop


fuse 56 and 57 control central locking,the issue is caused by surges typically in the front door lock actuators, normally at a dealer they would replace fuse 56 and 57 with a 20a mini fuse and if still occuring repl the door lock(s) that dont work or typically both front, first replace fuse 56 and 57 with 20a fuses as were too small from factory and than operate ten to 15 times, if it doesnt work at first dont panic,let the car go to sleep which takes about 16 min and than try again this problem has nothing to do with the key fob or the lock unlock button inside,also the fuses are located behind the glove box just rere the access panel and they are found at lower left section

Jul 23, 2009 | 2006 BMW 3 Series

1 Answer

Key Pad Entry does not work


does the key pad light when you press a button at night? If yes, the fuse is ok.
Do you have the plastic card with the permanent code in your owner manual packet? If yes, tryit.
report back.

Keyless Entry The keyless entry keypad is hardwired to the GEM. The GEM interprets the inputs from the keyless entry keypad and then controls the associated operation. The keyless entry keypad will be illuminated for five seconds when any button is pressed. Additionally, it will request the illuminated entry feature to turn the courtesy lamps on. If a lock all doors code is entered, the illumination will turn off, as well as request the illuminated entry feature to turn off the courtesy lamps. When pressed, the keyless entry keypad supplies the ground signal to the GEM or the GEM receives a signal from the keyless entry remote transmitter. Then the GEM outputs a ground signal to the appropriate lock or unlock relay which supplies the power to the actuator to lock or unlocks all doors, including the luggage compartment. The keyless entry remote transmitter also unlocks the liftgate or activates the panic alarm by sending a signal to the GEM.
--------------------------------------------------------------- Visual Inspection Chart Mechanical Electrical
  • Keyless entry keypad
  • Keyless entry remote transmitter
  • Central junction box (CJB) Fuse F222 (20A)
  • Circuitry
  • Generic electronic module (GEM)
------------------------------------------------------------------------
  • No communication with generic electronic module (GEM)
  • Generic electronic module.
  • Circuitry.
  • REFER to Section 419-10 .
------------------------------------------------------------------------------------

Mar 08, 2009 | 2003 Ford Taurus

Not finding what you are looking for?
2002 Jaguar X-Type Logo

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Raygin
Raygin

Level 2 Expert

322 Answers

yadayada
yadayada

Level 3 Expert

60867 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...